Transcription of Programmable 6AL-2 Ignition Control PN 6530
{{id}} {{{paragraph}}}
Example: dental hygienist
Programmable 6AL-2 Ignition Control PN 6530
Note: Solid core spark plug wires cannot be used with an MSD Ignition Control . Note: If you're programming the timing functions of the Ignition , the distributor must be locked Included:1 - Ignition Control , PN 65301 - MSD Pro-Data+ Software4 - Vibration Mounts and ScrewsAccessories:MAP Sensor, see page 6 Hand Held Programmer, PN 7550 Manual Launch RPM Control , PN 7551 WARNING: During installation , disconnect the battery cables. When disconnecting, always remove the Negative cable first and install it last. 3 - Deutsch Connector Harnesses 1 - Mag Pickup Harness, PN 88601 - Parts BagGENERAL INFORMATIONBATTERYThe MSD Programmable 6AL-2 Ignition Control will operate on any negative ground, 12 volt electrical system with a distributor.
4 INSTALLATION INSTRUCTIONS S UÊ WWW.MSDPERFORMANCE.COMÊ UÊ £x® Ê nxÇ xÓää Ê UÊ 8 Ê £x® Ê nxÇ ÎÎ{{WIRING Ignition supply wire, 14-gauge. Connects to battery positive (+) terminal or battery junction. Note: Do not connect to the alternator. Ignition ground, 14-gauge. Connect to battery negative (-) terminal or engine block.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: