Technical Information Proline Promag 50W, 53W

Proline Promag 50W, 53W Endress+Hauser 3 Function and system design Measuring principle Following Faraday's law of magnetic induction, a voltage is induced in a conductor moving through a magnetic field. In the electromagnetic measuring principle, the flowing medium is the moving conductor.

  Information, Technical, Promag, Proline, Proline promag 50w, Technical information proline promag 50w

Technical Information iTEMP HART TMT182 - …

Technical Information iTEMP ... Operating elements At the temperature transmitter no ope rating elements are available direct ly. The temperature transmitter will

  Information, Technical, Temperatures, Transmitter, Elements, Technical information, Temperature transmitter

Operating Instructions Flowphant T DTT31, DTT35

DL Clamp 2" (ISO 2852) or DN 50 (DIN 32676) LB Varivent F DN25-32, PN 40 LL Varivent N DN40-162, PN 40 HL APV-Inline, DN50, PN40, 316L, B = bores 6 x Ø8.6 (0.34 in) + 2 x thread M8 PL DIN 11851, DN50, PN40 (including coupling nut) PG …

  Operating, Instructions, Operating instructions, 32676, Din 32676

IECEx Certificate of Conformity - Endress+Hauser

IECEx Certificate of Conformity INTERNATIONAL ELECTROTECHNICAL COMMISSION IEC Certification Scheme for Explosive Atmospheres for rules and details of the IECEx Scheme visit www.iecex…

  Certificate, Conformity, Iecex, Iecex certificate of conformity

Technical Information Proline t-mass 65F, 65I

Proline t-mass 65F, 65I 4 Endress+Hauser Input Measured variable •Ma fssolw • Gas temperature • Gas heat flow Measuring range (air at ambient conditions) The measuring range is dependant on the gas selection, line size and use of flow conditioner.

Cerabar M PMC51, PMP51, PMP55 (Technische Information)

Cerabar M PMC51, PMP51, PMP55 6 Endress+Hauser Terms and abbreviations Term/abbreviation Explanation MWP The MWP (maximum working pressure) for the individual sensors depends on the lowest-rated element, with regard to

  Sensor, Cerabar m pmc51, Cerabar, Pmc51, Pmp51, Pmp55

Technical Information Proline t-mass 65F, 65I

Proline t-mass 65F, 65I 4 Endress+Hauser Function and system design Measuring principle The thermal principle operates by monitoring the cooling effect of a gas stream as it passes over a

  Thermal, Proline

Technical Information Waterpilot FMX21

Direct current A terminal to which DC voltage is applied or through which direct current flows. A0018336 Alternating currrent A terminal to which alternating voltage is applied or through which alternating current flows. A0018337 Direct current and alternating current • A terminal to which alternating voltage or DC voltage is applied.

  Direct, Current, Alternating, Direct current, Alternating current

Technical Information Liquiphant M FTL50, FTL51, FTL50H ...

Electronic versions FEL51: Two-wire AC version; Switches the load directly into the power supply circuit via an electronic switch. FEL52: Three-wire DC version; Switches the load via the transistor (PNP) and separate connection e.g. in conjunction with programmable logic controllers (PLCs), DI modules as per EN 61131-2. FEL54:

  Electronic, Programmable

Soliphant M FTM50, FTM51, FTM52

• Switch the loads via 2 floating change-over con-tacts (DPDT) ... FEM52 electronic insert (DC PNP) Power supply • DC voltage: 10 to 55 V • Ripple: max. 1.7 V, 0 to 400 Hz ... Preferably used with programmable logic controllers (PLC), DI modules as per EN 61131-2.

  Electronic, Load, Programmable, Soliphant, Soliphant m ftm50, Ftm50, Ftm51, Ftm52

Promag 53 HART (BA) - Endress+Hauser

Safety instructions Proline Promag 53 4 Endress+Hauser 1 Safety instructions 1.1 Designated use The measuring device described in this Operating Manual is to be used only for measuring the flow rate of conductive fluids in closed pipes. A minimum conductivity of 20 μS/cm is required for measurin g demineralized water. Most

  Manual, Operating, Promag, Operating manual, Promag 53