Transcription of REFERENCE STANDARD RS-10 STRUCTURAL WORK
{{id}} {{{paragraph}}}
REFERENCE STANDARD 10 REFERENCE STANDARD RS-10 STRUCTURAL work * LIST OF REFERENCED NATIONAL standards Building Code Requirements for Reinforced Masonry as 1960 ANSI/ACI-318 Building Code Requirements for Reinforced Concrete (with Modifications).. 1989 ACI-525 Minimum Requirements for Thin Section Precast Concrete Construction as 1963 **AISC Steel Specification for STRUCTURAL Steel Buildings, Allowable Stress Design and Plastic Design, Specification ASD June 1, 1989 **AISC Steel Load and Resistance Factor Design Specification for STRUCTURAL Steel Buildings, Effective Specification LRFD December 1, 1993 RCSCEF/AISC Specifications for STRUCTURAL Joints Using ASTM A325 or A490 Bolts.
reinforced unit masonry shall comply with reference standard RS 10-1B. **Local Law 17-995. 1.2 DIMENSIONS.-Unless the word "actual" is used, the dimensional requirements for masonry and for masonry units given in this standards are nominal. The measured dimensions of masonry shall be not more than 1/2 in. less than the required nominal dimensions.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}
THE APPENDICES AND REFERENCE, CODE, THE APPENDICES AND REFERENCE STANDARDS OF, Standards, Reference, Code Reference, Ethical PrinciPlEs of Psychologists and codE of conduct, Reference Standard 4 REFERENCE STANDARD, REFERENCE STANDARD RS-17, REFERENCE STANDARD RS 17, Reference standard RS, CFA Institute Code, CFA Institute, Universal Verification Methodology