Transcription of Rev 03 Parts List - .NET Framework
{{id}} {{{paragraph}}}
Example: quiz answers
Rev 03 Parts List - .NET Framework
Door frame Make sure hole in door frame is drilled a minimum of 1 (25 mm) toolsRuler4 AA BatteriesHammerWood blockPliersPhillips screwdriverAdditional Tools (depending on application)If drilling a new door, use the supplied template and the complete door drilling instructions available at : Additional door preparation may be required for doors with 1-1/2" (38 mm) holes. Consult the deadbolt drilling instructions at to confirm that the hole in the door is either 2-1/8" (54 mm) or 1-1/2" (38 mm).Measure to confirm that the backset is either 2-3/8" or 2-3/4" (60 or 70 mm).2-3/8" or 2-3/4"60 or 70 mm1-3/8" or 1-3/4"35 mm or 44 mmMeasure to confirm that the hole in the door edge is 1" (25 mm).Measure to confirm that the door is either 1-3/8" or 1-3/4" (35 mm or 44 mm) "54 mm1-1/2"38 mm1"25 mm1 Prepare the door and check dimensions2 Install the latch and strikeLatchExterior AssemblyInterior CoverStrikeSmartKey ToolAEJLMFGHBCDP arts ListDrive-In CollarKeysLatch and Strike ScrewsMounting PlateInterior Assembly ScrewsInterior AssemblyMounting Plate ScrewsAlign tabs with holes in (x2)K (x2)P (x2)B180 Is the door edge chiseled?
4 Install exterior assembly A Route the cable below the latch. Insert the torque blade through the horizontal slot in the latch. D G Secure the mounting plate with the supplied screws. IMPORTANT: Hold the exterior assembly on the outside firmly (or have a second
Loading..
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: