Transcription of RF Basics, RF for Non-RF Engineers - Texas Instruments
{{id}} {{{paragraph}}}
Example: bachelor of science
RF Basics, RF for Non-RF Engineers - Texas Instruments
2006 Texas Instruments Inc, Slide 1RF Basics, RF for Non-RF EngineersDag GriniProgram Manager, Low Power WirelessTexas Instruments 2006 Texas Instruments Inc, Slide 2 Basics Basic Building Blocks of an RF System RF Parameters and RF Measurement Equipment Support / getting startedAgenda 2006 Texas Instruments Inc, Slide 3 Definitions dBm relative to 1 mW dBc relative to carrier 10mW = 10dBm, 0dBm = 1mW -110dBm = 1E-11mW = For a 50 ohm load : -110dBm is , not much! Rule of thumb: Double the power = 3 dB increase Half the power = 3 dB decrease 2006 Texas Instruments Inc, Slide 4dBm to Watt About dBm and W Voltage Ratio aV = 20 log (P2/P1)[aV] = dB Power Ratio aP = 10 log (P2/P1)[aP] = dB Voltage LevelV = 20 log (V/1 V)[V ] = dB V Power LevelP = 10 log (P/1mW)[P ] = 25mW max. allowed radiated power in the EU SRD band >> P = 10 log (25mW/1mW) = 10 * 1,39794 dBm >> 14 dBm 2006 Texas Instruments Inc, Slide 5 Electromagnetic SpectrumSource: RADIATIONVHF = VERY HIGH FREQUENCYUHF = ULTRA HIGH FREQUENCYSHF = SUPER HIGH FREQUENCY EHF = EXTREMELY HIGH FREQUENCY4G CELLULAR56-100 GHzISM bandISM bands315-915 GHzISM= Industrial, Scientific and MedicalUWB= Ultra Wide Band 2006 Texas Instruments Inc, Slide 6 Frequency Spectrum Allocation Unlicensed ISM/SRD bands: USA/Canada: 260 470 MHz(FCC Part ; ) 902 928 MHz(FCC Pa)
Receiver Architecture • Super heterodyne receiver – e.g. CC1000 Converts the incoming signal to an Intermediate Frequency (IF) signal and performs: 1.Carrier frequency tuning – selects desired signal 2.Filtering – separates signal from other modulated signals picked up 3.Amplification – compensates for transmission losses in the ...
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: