Transcription of Rubrik Complete: Quick Start Guide
{{id}} {{{paragraph}}}
Example: marketing
Rubrik Complete: Quick Start Guide
Rubrik COMPLETE: Quick Start Guide . Rack & Stack Bootstrap checklist - RACK & STACK SWITCH CONFIGURATION checklist - BOOTSTRAP Default Password: Rubrik Appliance(s) are racked, stacked and The Rubrik cluster network connections must be plugged into access port(s) or native VLAN port(s). Connect to a node have power Rubrik does not support bootstrap on trunk link port(s). Example: Ansible to Bootstrap Cluster Validate all nodes are discoverable Appliance(s) are cabled correctly The network switch must have Link Layer Discovery Protocol (LLDP) enabled. Run Bootstrap on node Complete Pre-Installation Worksheet Rubrik uses multicast DNS (mDNS) for node-to-node discovery and to initiate system set up as well as node adds Obtain a Support Portal login by sending IPv6 support enabled an email to: AC Power Supplies Node D Node B.
QUICK START GUIDE Bootstrap. Configure Cluster Register with GPS. CHECKLIST - RACK & STACK. Appliance(s) are racked, stacked and have power Appliance(s) are cabled correctly Complete Pre-Installation Worksheet Obtain a Support Portal login by registering for access. NODE LOCATIONS. The following figure shows the rear of . an r6000 series ...
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: