Transcription of SECTION 24 TIMING BELT DRIVE SELECTION PROCEDURE …
{{id}} {{{paragraph}}}
Example: tourism industry
SECTION 24 TIMING BELT DRIVE SELECTION PROCEDURE …
T 146 SECTION 24 TIMING belt DRIVE SELECTION PROCEDUREStep 1 Determination of design loadDrives consist of a driver and a driven pulley. In general, both pulleys are not of the samesize; therefore, a speed reduction or increase occurs. Both convey the same power; however, thetorque on each pulley is different. DRIVE designs should be based on the smaller pulley which willbe subject to higher peak design load must be taken into account, and it is obtained by multiplying the torqueby a service factor.
TÐ146 SECTION 24 TIMING BELT DRIVE SELECTION PROCEDURE Step 1 Determination of design load Drives consist of a driver and a driven pulley. In general, both pulleys are not of the same
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: