Transcription of Series with RedLINK Installation Guide
{{id}} {{{paragraph}}}
VisionPRO Series with RedLINK Installation GuideTMTMORORW ired Directly to Equipment2 Wires for Power orBattery Only (no wires)2 Wires for Power orBattery Only (no wires)Dual Powered - C Wire or Battery(C wire or Wire Saver required to use RedLINK accessories) RedLINK to Equipment Interface ModuleRedLINK to TrueZONE Wireless AdapterTM 2 Current display. Underlined label signifies the current control buttons. Use to change settings for Fan or System Select options to: set schedules, view equipment status, change IAQ settings, access installer options*, status.
HEAT PUMP 1.3b For 24VAC primary power, connect common side of transformer to C terminal. 1.2 Mount wallplate as shown. Mount new wallplate using screws and anchors included with the thermostat. Drill 3/16-in holes for drywall. Drill 7/32-in holes for plaster. Thermostat (back view) Wallplate (back view) Wallplate S1 S1 W Y G W2 Y2 A C K RC R ...
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}