Transcription of SINAMICS DCM - Siemens
{{id}} {{{paragraph}}}
High-performance drivesSINAMICS DCMBase Drive panel instructions version software version:As these Operating Instructions went to print, SINAMICS DCM converters were being delivered from the factory with software version Operating Instructions also apply to other software software versions: Some parameters described in this document might not be available in the software ( the corresponding functionality is not available on the converter ) or some parameters will have a restricted setting range. SINAMICS DCM Base Drive Panel series requires software version or software versions: Additional parameters might be available on the SINAMICS DCM ( extra functions might be available which are not described in these Operating Instructions) or some parameters might have an extended setting range. In this case, leave the relevant parameters at their factory setting, or do not set any parameter values which are not described in these Instructions!
Converter software version: As these Operating Instructions went to print, SINAMICS DCM converters were being delivered from the factory with software version 1.4 installed. These Operating Instructions also apply to other software versions. Earlier software versions: Some parameters described in this document might not be available in the software (i.e. the …
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}