Transcription of Solar Tracking Structure Design
{{id}} {{{paragraph}}}
Example: biology
Solar Tracking Structure Design
Solar Tracking Structure Design By Hashem Bukhamsin, Angelo Edge, Roger Guiel, Dan Verne Team 18 Final Project Report Document Submitted towards partial fulfillment of the requirements for Mechanical Engineering Design I Fall 2013 Department of Mechanical Engineering Northern Arizona University Flagstaff, AZ 86011 Solar Power Tracking System Task 3-Power Point Tracking for Solar Energy Northern Arizona University (NAU) NAU College of Engineering, Forestry and Natural Science Team SOLAREADY: Hashem Bukhamsin, Angelo Edge, Roger Guiel, Dan Verne, Majad Alharbi, Curt DuRocher, M. Ian Farnsworth, Michael Helland, Dustin Sagg Advisors: Dr. Tom Acker, Dr. David Scott and Professor Srinivas Kosaraju March 21, 2014 Task 3 Northern Arizona University | 1 TABLE OF CONTENTS Executive Summery.
The solar panel support frame is made of stock metal to reduce weight. Because the solar panels only weigh 24 pounds each, the metal should have no problem supporting the load as seen in the structural analysis section bellow. The panels are fixed to the frame with the use of small brackets that bolt into the solar panel support frame.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: