PDF4PRO ⚡AMP

Modern search engine that looking for books and documents around the web

Example: tourism industry

Spa Owner’s Manual

Unit is IPX5 CompliantFeaturing our patented, maintenance-free DURA-LAST Cabinet System with HEATSHIELD Insulation Technology Pat. 7,784,120 PLEASE READ AND FOLLOW ALL INSTRUCTIONS For Customer Service and Technical Support, please contact us at: or 1-800-787-6649 Spa Owner s ManualSpa Owner s Manual2 Congratulations on your purchase!Your new spa will bring you years of enjoyment and take the time to familiarize yourself with the safety precautions,operational procedures, routine water maintenance and cleaning so that your spa will provide a healthy environment for all your !Customer Service 1 800 787 6649 3 ContentsImportant Safety Instructions and Warnings .. 4 Prepare for Your New SpaPlan the Best Location .. 6 Identifying the Spa s Electrical Components .. 7 Electrical Installation (120 V 60HZ North America).. 8120v to 240v Conversion (Plug & Play Models Only) .. 9 Electrical Installation (240 V 60HZ North America).. 11 GFCI Wiring Diagram (240 V 60HZ North America).

tion. If you are installing the spa indoors (not rec-ommended), pay close attention to the flooring beneath it. Choose flooring that will not be dam-aged or stained. If you are installing your spa on an elevated wood deck or other structure, consult a structural engineer or a contractor to ensure the structure will support the weight of 150 ...

Fullscreen Download
Loading..

Tags:

  Installing

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Spam in document Broken preview Other abuse

Transcription of Spa Owner’s Manual

Related documents

Installing and Testing a GFCI Receptacle

www.leviton.com

Installing and Testing a GFCI Receptacle Please read this leaflet completely before getting started. LINE AB C LOAD Service Panel LOAD LINE LINE! CAUTION • To prevent severe shock or electrocution always turn the power OFF at the service panel before working with wiring. • Use this GFCI with copper or copper-clad wire. Do not use it with ...

  Testing, Installing, Figc, Installing and testing a gfci

Bathroom Inspection - Building in California

www.buildingincalifornia.com

☐ Light fixtures in wet locations shall be protected by GFCI circuit CEC 410.4 (A)(D) (Per the manufacturer’s installation instructions) ☐ Separate circuits for lights & receptacle outlets. CEC 210-11 (c)(3) Plumbing ☐ Testing piping system: Drain, waste, & vent (DWV) system shall be tested with no less than 10’ of head water above the

  Testing, Figc

HOME ELECTRICAL Safety Checklist

www.cpsc.gov

NO: Test every GFCI once a month according to the manufacturer’s instructions. If you do not have the instructions follow this procedure: 1) Plug a light into the outlet and turn it on. 2) Press the test button. Did the light go out? If not, replace the GFCI. 3) Press the reset button. Did the light come back on? If not,

  Checklist, Safety, Figc, Safety checklist

Trailblazer 325 - Miller

www.millerwelds.com

Use GFCI protection when operating auxiliary equipment. Do not test or reset GFCI receptacles at idle speed/low voltage or the shock caused by a ground fault. SIGNIFICANT DC VOLTAGE exists in inverter power sources AFTER stopping engine. Stop engine on inverter and discharge input capacitors according

  Figc

Trailblazer 302 Trailblazer 275 DC - Miller

www.millerwelds.com

Disconnect input power or stop engine before installing or servicing this equipment. Lockout/tagout input power according to OSHA 29 CFR 1910.147 (see Safety Standards). Properly install, ground, and operate this equipment according to its Owner’s Manual and national, state, and local codes.

  Installing

Related search queries

Installing and Testing a GFCI, GFCI, Testing, Safety Checklist, Installing