Specification for Structural Joints Using ASTM A325 or ...

Specification for Structural Joints Using ASTM A325 or A490 Bolts June 30, 2004 Supersedes the June 23, 2000 Specification for Structural Joints Using ASTM A325 or A490 by RCSC Committee Specifications and approved by the Research council on Structural Connections. RESEARCH council ON Structural CONNECTIONS c/o American Institute of Steel Construction, Inc. One East Wacker Drive, Suite 3100, Chicago, Illinois 60601-2001 ii Copyright 2004byResearch council on Structural Connections All rights reserved. This book or any part thereof must not be reproduced in any form without the written permission of the information presented in this publication has been prepared in accordance with recognized engineering principles and is for general information only. While it is believed to be accurate, this information should not be used or relied upon for anyspecific application without competent professional examination and verification of its accuracy, suitability, and applicability by a licensed engineer, architect or otherdesign professional.

The first Specification approved by the Council, called the Specification for Assembly of Structural Joints Using High Tensile Steel Bolts, was published in January 1951. Since that time the Council has published fifteen successive editions. Each was developed through the deliberations and approval of the full Council membership and

Tags:

  Using, Specification, Council, Structural, Joint, Specification for structural joints using

Information

Related search queries