Transcription of Spur Gear Selection - Cross & Morse
{{id}} {{{paragraph}}}
Example: air traffic controller
Spur Gear Selection - Cross & Morse
Tel +44 121 360 0155 Fax +44 121 325 1079 Email For a required centre distance and gear ratio a suitable pair of spurgears can be selected used and assessed by the following numbers of teeth in gears and module (pitch). gear Ratio i = Shaft centre distance in mm = sum gear teeth xpitch= (Z1+ Z2) PFrom this initial Selection each gear can be assessed for strength andwear using the following formulae. The least of the four calculatedpowers is the capacity of the gear set. The capacity required isdetermined by multiplying actual power by a service factor relativeto driver and driven equipment, refer page 3.
Tel +44 121 360 0155 Fax +44 121 325 1079 Email sales@crossmorse.com For a required centre distance and gear ratio a suitable pair of spur
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: