Transcription of Standard Operating Procedure for - Fisher Sci
{{id}} {{{paragraph}}}
Standard Operating Procedure for: Total Suspended Solids ID: TSSolids Revision: 2 May 2007 Page 2 of 11 Table of Contents 1 Identification of the test method .. 3 2 Applicable matrix or matrices: .. 3 3 Detection Limit .. 3 4 Scope of the test method .. 3 5 Summary of test 3 6 Definitions .. 3 7 Interferences .. 3 8 Health and safety .. 4 9 Personnel qualifications .. 4 10 Equipment and supplies .. 4 11 Reagents and standards .. 4 12 Sample collection, preservation, shipment and storage .. 4 13 Quality control .. 5 14 Calibration and standardization.
c. Heat filters for a minimum of 1 hour to ensure that filters are dry. d. Remove filters from the oven and place them into a desiccator until they have cooled to balance temperature. e. Weigh each filter, recording all measurements to 0.1 mg precision. f. Record the mass of the filter on the bench sheet as the Filter Tare Mass in mg. g.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}