Transcription of STATIC PILE LOAD TEST MANUAL - New York State …
{{id}} {{{paragraph}}}
STATIC pile load TEST MANUAL GEOTECHNICAL CONTROL PROCEDURE GCP-18 Revision #4 AUGUST 2015 EB 15-025 Page 1 of 55 GEOTECHNICAL CONTROL PROCEDURE: STATIC pile load TEST MANUAL GCP-18 Revision #4 State OF NEW YORK DEPARTMENT OF TRANSPORTATION GEOTECHNICAL ENGINEERING BUREAU AUGUST 2015 EB 15-025 Page 2 of 55 TABLE OF CONTENTS I. pile TEST LOADS AND load APPLICATION SYSTEMS ..5 A. Types of Reaction Loads ..5 B. load Application System ..8 II. MEASURING APPARATUS AND SITE PROTECTION ..10 A. Primary System ..10 B. Auxiliary Systems ..24 C. Settlement Reference Points ..24 D. Site Protection ..25 III. REQUIREMENTS PRIOR TO TESTING ..26 A. Waiting Period ..26 B. Control of pile Heave ..26 C. Special Procedures for Cast-In-Place Piles and Drilled Shafts ..26 D. Special Procedure for Micropiles ..28 IV. pile AND STATIC pile load TEST CRITERION ..29 A. pile Failure Criteria.
The Constant Rate of Penetration Test. The Contractor must engage the services of a Professional Engineer licensed and registered in New York State, experienced in all aspects of pile load testing and acceptable to the Deputy Chief Engineer Structures (D.C.E.S) to perform the load tests and to prepare report of test results,
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}