Transcription of STEEL PIPE - Antec Engineering
{{id}} {{{paragraph}}}
STEEL PIPEMEDIUM & HEAVY PIPEMEDIUM & HEAVY PIPE4 MANUFACTURING PROCESSG rade C250 pipe , for general mechanical and lowpressure reticulation applications, is manufactured bycold-forming and high frequency Electric ResistanceWelding. The cold-forming process enhances the strength,hardness and surface finish of the pipe and producesproduct to tight dimensional tolerances. pipe is tested byusing non-destructive Eddy Current methods during STANDARDSG rade C250 pipe is manufactured and tested to complywith the requirements of the following specifications:AS 1074 - STEEL tubes and tubulars for ordinary 1163 - Structural STEEL hollow sections(Grade C250, C250LO).AS 4792 - Hot-dipped galvanised coating on ferroushollow sections. Applied by a continuous or a grades with guaranteed impact performancesat 0 C. With impact guaranteed properties, theopportunities for the designer are now enhanced in lowtemperature service environments under AS PROPERTIESM inimum Yield Strength250 MPaMinimum Tensile Strength320 MPaMinimum Elongation in So22%TOLERANCESS traightnessThickness ToleranceDimensional ToleranceLength Tolerance+50mm/-0mmIf tighter tolerances are required, they must be specifiedat the time of order (conditions apply).
LIGHT AND EXTRA LIGHT PIPE 6 Grade C350 MASS AND BUNDLING DATA - Calculated in accordance with AS 1163 Grade C350 Pipe is a lightweight, high strength pipe …
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}
Stainless Steel Pipe Specifications, Steel pipe, Suggested Specifications: Steel Pipe for, Suggested Specifications - Steel Pipe for, Specifications, SPECIFICATIONS FOR STEEL PIPE, Pipe, PIPE SPECIFICATIONS, Welded Steel Pipe, SUBJECT: Pipe Installation Specifications, AWWA C200 Steel Water Pipe, AWWA C200 Steel Water Pipe Manufacturing Standard: Consensus-Based Changes