Transcription of Sure Stop Detonation and Flame Arrestors Technical Data
{{id}} {{{paragraph}}}
Example: tourism industry
Sure Stop Detonation and Flame Arrestors Technical Data
TORNADO Technologies Inc. 3236 - 50 Avenue SE, Calgary, Alberta, Canada T2B 3A3 : 403-244-3333 Fax: 403-245-1821 Stop Detonation and Flame ArrestorsTechnical Data Any ignition source (ie. flare or incinerator) creates an explosive opportunity for Flame fronts to propogate back through lines, destroying facilities and causing injuries. An arrestor is a passive safety device designed to disperse a Flame front, release its energy, and cool it to below the ignition point of that vapour. The following document will assist in choosing the correct arrestor for your application. Included are: Design Sheets General Dimensions & Weights Flow Capacity Curves DA ClassificationsTORNADO Technologies Inc. Tel: 403-244-3333 Fax: 403-245-1821 DESIGN INFORMATION Type: Detonation arrestor Inline Flame arrestor End-Of-Line Flame ArrestorInstallation: Horizontal Ver tical Other (angle)Materials: Housing Element Housing Element (Aluminum 304L Stainless Steel 316L Stainless Steel Other)Connections: Inlet Size: (NPT) Flange Pressure Rating: (ANSI 150 lb RF Standard)Standard Detonation arrestor confi guration comes with: 2 x Differential Pressure Por ts 2 x Thermocouple Por ts 2 x Drain Por tsCoating/Special Paint: Additional Info: PROCESS INFORMATION * Please ensure details are complete and accurate so that our Technical team can provide the best recommendation for product and Flo
TORNADO Technologies Inc. • Tel: 403-244-3333 • Fax: 403-245-1821 • www.tornadotech.com Detonation and Flame Arrestors Design Sheet STREAM COMPOSITION Component Mole Percent Mole Fraction TOTALS: LINE DIAGRAM
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: