Transcription of Technical Data Sheet
{{id}} {{{paragraph}}}
Example: confidence
Technical Data Sheet
^(ValidationDate)29202920;24011epoxyTech nical Data SheetPenguard Express ZPProduct descriptionThis is a two component amine cured epoxy coating. It is a fast drying, zinc phosphate pigmented, high solids,high build product. Specially designed for new construction where short dry to handle and over coating times are required. Can be used as primer, mid coat, finish coat or as single coat system in atmospheric for properly prepared carbon steel substrates. It can be applied at sub zero surface , redTypical useOther variants availablePenguard ExpressPenguard Express MIOP enguard Express CFSuitable for structural steel and piping to be exposed to highly corrosive environments, C5I or C5M (ISO 12944-2). Recommended for offshore environments, refineries, power plants, bridges, buildings and mining to separate TDS for each dataPropertyTest/StandardDescriptionSoli ds by volume 2 %Gloss level (GU 60 )ISO 2813 VOC-US/Hong KongUS EPA method 24 (tested)(CARB(SCM)2007, SCAQMD rule 1113, Hong Kong)VOC-EUIED (2010/75/EU) (theoretical)The provided data is typical for factory produced products, subject to slight variation depending on pointISO 3679 Method 132 Cmatt (0-35)260 g/l277 description: According to J
Drying and Curing time Surface (touch) dry Walk-on-dry 16 h11 h4 h2 h1 h30 min 38 h24 h10 h6 h3 h2 h 21 d13 d8 d4 d3 d Substrate temperature 0 °C5 °C10 °C23 °C40 °C Dried/cured for service-5 °C Dry to over coat, minimum 24 h14 h8 h4 h2 h1 h Walk-on-dry: Minimum time before the coating can tolerate normal foot traffic without permanent marks,
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: