Transcription of Technical Description ALIMAK SCANDO 650 Construction …
{{id}} {{{paragraph}}}
Example: biology
Technical Description ALIMAK SCANDO 650 Construction …
Technical DescriptionALIMAK SCANDO 650 Construction Hoists YOUR HOIST HAS:Manufacturing No.:Year:Part No. 9100272 - 1 082008 - 05 - 27If the bottom right corner of this book is cut, the book is only valid for illustrative use!This manual is only applicable if the manufacturing number indicated below corresponds to the manufacturing number stamped on the identificationsign of the equipment. Where there is a conflict contact your ALIMAK TranslationPhotographs and drawings are illustrative only and do not necessarily show the design of the products on the market at any given point in products must be used in conformity with applicable practice and safety regulations. Specifications of the products and equipmentpresented herein are subject to change without DESCRIPTIONTECHNICAL DATA & SPECIFICATIONSIMPORTANT SAFETY INSTRUCTIONSOPERATING INSTRUCTIONSSERVICE AND MAINTENANCEELECTRIC TROUBLESHOOTINGFOUNDATIONHOIST MASTPREPARATIONS BEFORE INSTALLATIONSee Operator s Manual for chapter C, D, E and and illustrations by H kan Lindstr ALIMAK AB 2004.
The electro hydraulic power pack is located on the floor portion of the gate/ramp section. A 2.5 m (8’- 2 1/2’’)wide full height entrance door with C-side location can be furnished for the 2.8 m car base structure and a 3.2 m (10’- 6’’)wide full height entrance door with C-side location for the 3.5 m car base structure. Doors of C ...
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: