Transcription of Technical Information - ALAN GROVE COMPONENTS
{{id}} {{{paragraph}}}
Technical Information PULLEY DIMENSIONS. - Our brackets are designed for the factory steel Chevrolet standard groove pulleys. While some aftermarket pulleys may work; they must be manufactured with the same groove offset as the factory Chevrolet pulleys in order to be used with our brackets. - Center to center of the pulley grooves must measure 5/8 . AGC brackets are not desinged to work with deep groove pulleys. - Check pulley dimensions below to insure correct belt alignment for your application. All measurements are from the center of the pulley groove to the machined front surface of the engine block (timing chain cover and water pump mounting surface). SMALL BLOCK CHEVY. Short Water Pump Long Water Pump Machined Face of Block Machined Face of Block 3 7/ 8 5 3/ 8.
PULLEY DIMENSIONS Technical Information - Our brackets are designed for the factory steel Chevrolet standard groove pulleys. While some aftermarket pulleys may work; they must be manufactured with the same groove offset as the factory
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}