Transcription of TEST METHOD FOR EARTHWORK COMPACTION CONTROL …
{{id}} {{{paragraph}}}
TEST METHOD FOR EARTHWORK COMPACTION CONTROL BY NUCLEAR GAUGE GEOTECHNICAL TEST METHOD GTM-10 Revision #5 AUGUST 2015 EB 15-025 Page 1 of 11 GEOTECHNICAL TEST METHOD : TEST METHOD FOR EARTHWORK COMPACTION CONTROL BY NUCLEAR GAUGE GTM-10 Revision #5 STATE OF NEW YORK DEPARTMENT OF TRANSPORTATION GEOTECHNICAL ENGINEERING BUREAU AUGUST 2015 EB 15-025 Page 2 of 11 TABLE OF CONTENTS 1. SCOPE ..3 2. SUMMARY OF METHOD ..3 3. LICENSING AND CERTIFICATION ..3 Licensing ..3 Certification ..3 4. TEST PROCEDURE ..4 Preparation Prior to Testing ..4 Test Location Data ..5 Testing and Sampling ..5 5. DATA AND CALCULATIONS ..6 Determination of Plus in. (19 mm) Material and Moisture Content ..7 CONTROL Density ..8 APPENDIX ..11 A. Equipment .. A-1 B. Illustration Showing Where Material for One Point Proctor Test is Obtained - Figure B-1 C. Density Correction Curves Plus in. (19 mm) Material Specific Gravity.
Form SM 418b is used for recording compaction test data. Refer to this form in Appendix F. Form SM 418b uses US Customary Units (lbs.) for recording the larger weights (test sample & tare, tare, Plus ¾ in. (19 mm) Material, etc.). 4.2.1 Before starting the test, enter all the information required at the top of
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}