PDF4PRO ⚡AMP

Modern search engine that looking for books and documents around the web

Example: quiz answers

TEST METHOD FOR EARTHWORK COMPACTION CONTROL …

TEST METHOD FOR EARTHWORK COMPACTION CONTROL BY NUCLEAR GAUGE GEOTECHNICAL TEST METHOD GTM-10 Revision #5 AUGUST 2015 EB 15-025 Page 1 of 11 GEOTECHNICAL TEST METHOD : TEST METHOD FOR EARTHWORK COMPACTION CONTROL BY NUCLEAR GAUGE GTM-10 Revision #5 STATE OF NEW YORK DEPARTMENT OF TRANSPORTATION GEOTECHNICAL ENGINEERING BUREAU AUGUST 2015 EB 15-025 Page 2 of 11 TABLE OF CONTENTS 1. SCOPE ..3 2. SUMMARY OF METHOD ..3 3. LICENSING AND CERTIFICATION ..3 Licensing ..3 Certification ..3 4. TEST PROCEDURE ..4 Preparation Prior to Testing ..4 Test Location Data ..5 Testing and Sampling ..5 5. DATA AND CALCULATIONS ..6 Determination of Plus in. (19 mm) Material and Moisture Content.

For direct reading gauges; enter, on Form SM 418b lines H, J. K and L, the set of test data obtained at the highest Total Wet Density reading. 4.3.3 Use the spade to remove approximately 15 lbs. (7 kg) of material from the cross hatched area shown on Figure 2, Appendix B. Place the material in the tare; it will

Loading..

Tags:

  Direct, Reading, Direct reading

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Spam in document Broken preview Other abuse

Transcription of TEST METHOD FOR EARTHWORK COMPACTION CONTROL …

Related search queries