Code of Practice for Safety at Work (Lift and Escalator)

Code of Practice for Safety at Work (Lift and Escalator) Occupational Safety and Health Branch Labour Department October 1997

Chapter 4: Rest Days, Holidays and Leaves - …

Chapter 4: Rest Days, Holidays and Leave. An employee shall enjoy rest days, statutory holidays and paid annual leave during employment. REST DAY

Practical Guide for Employment of FDHs Eng - …

Practical Guide For Employment Of Foreign Domestic Helpers – What foreign domestic helpers and their employers should know . Table of Contents

A Concise Guide to the Employees ... - labour.gov.hk

A Concise Guide to the Employees’ Compensation Ordinance (with Frequently Asked Questions on Common Employees’ Compensation Issues) Labour Department

  Labour

工傷意外通知書 - labour.gov.hk

請在適用方格內劃上「 」號 請轉後頁 勞工處檔案編號： 工傷意外通知書 . 本人（下稱僱員）在受僱工作期間因工遭遇意外受傷，詳情如下（附註1）：

  Labour

Printed by the Government Logistics Department

Report of the Policy Study on Standard Working Hours Table of Content Table of Content Page Executive Summary 1 Part I – Background Chapter 1 Introduction 15

to the Employment (Amendment) Ordinance

Summary of Amendments made under the Amendment Ordinance II • The Revised Mode of Calculation Calculating relevant statutory entitlements on the basis

  Calculating, Statutory

Lighting Assessment in the Workplace - labour.gov.hk

3. Approaches to Lighting Assessment There are basically two approaches to conducting a lighting assessment in the workplace: by means of a checklist and by

  Lighting

Chapter 1: Application of the Employment Ordinance

Chapter 1: Application of the Employment Ordinance. The Employment Ordinance applies to all employees with the following exceptions: 1. a family member who lives in the same dwelling as the employer;

  Employment, Ordinance, Employment ordinance

A Concise Guide to the Employment Ordinance

2 Foreword This guide sets out in simple terms the main provisions of the Employment Ordinance (Cap. 57). It should be noted that the Ordinance itself remains the

  Guide, Employment, Ordinance, Concise, Employment ordinance, A concise guide to the employment ordinance

Guide to Safe Slinging and Signalling

• Scaffold cranes. The Laing O’Rourke A4 booklet ‘The Safe Operation of Cranes’ (below) contains the arrangements for the overall management of lifting operations. Those arrangements are mandatory for all Laing O’Rourke crane operations and a copy of the booklet is held by the appointed person. The Safe Operation of Cranes

  Operations, Safe, Crane, Signalling, The safe operation of cranes, Slinging, Safe slinging and signalling

The Safe Operation of Cranes - Health and Safety Hub

THE SAFE OPERATION OF CRANES INTRODUCTION THE SAFE OPERATION OF CRANES This document is issued with the authority of Laing O’Rourke. It must be adhered to on every site or other place of work in the United Kingdom where the company, its subsidiaries and/or their sub-contractors are using cranes.

  Operations, Safe, Crane, The safe operation of cranes

‘Struck-By’ Hazards

heavy equipment and vehicles, likes trucks and cranes; ... Train all workers on safe operation of tools, and inspect all tools before use. 12. Train workers on safe operation of power tools, such as saws, drills, and grinders. Inspect all tools before use, and wear protective gear. Guard rotating and moving parts – all guards

  Operations, Safe, Hazards, Crane, Struck, Safe operation, Struck by hazards

HYDRAULIC CRAWLER CRANE - Kobelco Cranes

means of switch operation. • The hoist lever interlock helps to ensure safety during preparatory operations by preventing the drums from responding to accidental lever movement. • The boom-drum pawl detection device sounds an alarm if the operator forgets to engage the drum locks. • Tower-angle lock switch: By locking the tower at a set ...

  Operations, Hydraulic, Crane

EM385-1-1 Section 16 TOCFINAL

(LHE) to include cranes, derricks, hoists and power-operated equipment that can be used to raise, lower and/or horizontally move a suspended load. ... necessary for the safe operation of the equipment and attachments according to: a. Procedures for the operational controls that must be developed by a Qualified Person (QP).

  Operations, Safe, Crane, The safe operation

API Standards for Safe Offshore Operations

Design, Installation, Repair and Operation of Subsurface Safety Valve Systems Analysis, Design, Installation, and Testing of Basic Surface Safety Systems for Offshore Production Platforms RP 2 RP 2MET/ISO 19901-1:2006 RP 2MOP/ISO 19901-6:2009 RP 2N/ISO 19906:2010 STD 2RD RP 2SIM RP 2T BULL 2TD RP 2X RP 95J SPEC 14A RP 14B RP 14C Drill-Through ...

  Operations, Safe

ANSI B20.1: Safety Code for Conveyors, Cableways, and ...

This code is intended as a guide for the safe construction, elements of design, installation. operation and maintenance of conveyors and cOn\'e~'in~ machinery, such as power conveyors, gravity conveyors, pneumatic tubes, cablewa}'s, etc., but not including underground …

  Operations, Safe, Ansi, The safe

The Guide to Cal/OSHA

• Issuing permits for operation of elevators, amusement rides, and aerial passenger tramways. • Inspecting mines, tanks, and boilers. Also, current legislation affecting the Cal/OSHA program includes unique requirements concerning cranes, construction permits,

  Operations, Crane

A Brief Introduction to Important Vessel Mooring Techniques

operation lies with master of the ship (In case pilot is taking the lead, he will be responsible for the coordination) and not the shore/port mooring party. The port authority also plays an important role to arrange the berth and equipment for ship to get alongside which also requires moving of cranes away from the area until the

  Operations, Crane, Of cranes

Preventing accidents during lifting operations

d) The lifting operation should be appropriately supervised 2) Ensure that the lifting operations are properly co-ordinated, so all trades working on site know about the operation, and not put to risk. 1) Before starting work, make sure you have been properly briefed 2) Take the time to check the lifting plan against what you actually see on site

  Operations