Example: barber
This Code of Practice is prepared by the
Code of Practice for Safe Use of Tower Cranes 2 1. Scope 1.1 1.2 1.3 This Code provides guidance on the safe use and operation of tower cranes to ensure the safety of personnel working at or nearby those cranes. This Code covers management and planning of the lifting operation of tower
Tags:
Information
Domain:
Source:
Link to this page:
Documents from same domain
Code of Practice for Safety at Work (Lift and Escalator)
www.labour.gov.hkCode of Practice for Safety at Work (Lift and Escalator) Occupational Safety and Health Branch Labour Department October 1997
Chapter 4: Rest Days, Holidays and Leaves - …
www.labour.gov.hkChapter 4: Rest Days, Holidays and Leave. An employee shall enjoy rest days, statutory holidays and paid annual leave during employment. REST DAY
Practical Guide for Employment of FDHs Eng - …
www.labour.gov.hkPractical Guide For Employment Of Foreign Domestic Helpers – What foreign domestic helpers and their employers should know . Table of Contents
A Concise Guide to the Employees ... - labour.gov.hk
www.labour.gov.hkA Concise Guide to the Employees’ Compensation Ordinance (with Frequently Asked Questions on Common Employees’ Compensation Issues) Labour Department
工傷意外通知書 - labour.gov.hk
www.labour.gov.hk請在適用方格內劃上「 」號 請轉後頁 勞工處檔案編號： 工傷意外通知書 . 本人（下稱僱員）在受僱工作期間因工遭遇意外受傷，詳情如下（附註1）：
Printed by the Government Logistics Department
www.labour.gov.hkReport of the Policy Study on Standard Working Hours Table of Content Table of Content Page Executive Summary 1 Part I – Background Chapter 1 Introduction 15
to the Employment (Amendment) Ordinance
www.labour.gov.hkSummary of Amendments made under the Amendment Ordinance II • The Revised Mode of Calculation Calculating relevant statutory entitlements on the basis
Lighting Assessment in the Workplace - labour.gov.hk
www.labour.gov.hk3. Approaches to Lighting Assessment There are basically two approaches to conducting a lighting assessment in the workplace: by means of a checklist and by
Chapter 1: Application of the Employment Ordinance
www.labour.gov.hkChapter 1: Application of the Employment Ordinance. The Employment Ordinance applies to all employees with the following exceptions: 1. a family member who lives in the same dwelling as the employer;
A Concise Guide to the Employment Ordinance
www.labour.gov.hk2 Foreword This guide sets out in simple terms the main provisions of the Employment Ordinance (Cap. 57). It should be noted that the Ordinance itself remains the
Related documents
Guide to Safe Slinging and Signalling
docs.healthandsafetyhub.co.uk• Scaffold cranes. The Laing O’Rourke A4 booklet ‘The Safe Operation of Cranes’ (below) contains the arrangements for the overall management of lifting operations. Those arrangements are mandatory for all Laing O’Rourke crane operations and a copy of the booklet is held by the appointed person. The Safe Operation of Cranes
The Safe Operation of Cranes - Health and Safety Hub
docs.healthandsafetyhub.co.ukTHE SAFE OPERATION OF CRANES INTRODUCTION THE SAFE OPERATION OF CRANES This document is issued with the authority of Laing O’Rourke. It must be adhered to on every site or other place of work in the United Kingdom where the company, its subsidiaries and/or their sub-contractors are using cranes.
‘Struck-By’ Hazards
www.osha.govheavy equipment and vehicles, likes trucks and cranes; ... Train all workers on safe operation of tools, and inspect all tools before use. 12. Train workers on safe operation of power tools, such as saws, drills, and grinders. Inspect all tools before use, and wear protective gear. Guard rotating and moving parts – all guards
HYDRAULIC CRAWLER CRANE - Kobelco Cranes
www.kobelco-cranes.commeans of switch operation. • The hoist lever interlock helps to ensure safety during preparatory operations by preventing the drums from responding to accidental lever movement. • The boom-drum pawl detection device sounds an alarm if the operator forgets to engage the drum locks. • Tower-angle lock switch: By locking the tower at a set ...
EM385-1-1 Section 16 TOCFINAL
www.usace.army.mil(LHE) to include cranes, derricks, hoists and power-operated equipment that can be used to raise, lower and/or horizontally move a suspended load. ... necessary for the safe operation of the equipment and attachments according to: a. Procedures for the operational controls that must be developed by a Qualified Person (QP).
API Standards for Safe Offshore Operations
www.api.orgDesign, Installation, Repair and Operation of Subsurface Safety Valve Systems Analysis, Design, Installation, and Testing of Basic Surface Safety Systems for Offshore Production Platforms RP 2 RP 2MET/ISO 19901-1:2006 RP 2MOP/ISO 19901-6:2009 RP 2N/ISO 19906:2010 STD 2RD RP 2SIM RP 2T BULL 2TD RP 2X RP 95J SPEC 14A RP 14B RP 14C Drill-Through ...
ANSI B20.1: Safety Code for Conveyors, Cableways, and ...
law.resource.orgThis code is intended as a guide for the safe construction, elements of design, installation. operation and maintenance of conveyors and cOn\'e~'in~ machinery, such as power conveyors, gravity conveyors, pneumatic tubes, cablewa}'s, etc., but not including underground …
The Guide to Cal/OSHA
www.dir.ca.gov• Issuing permits for operation of elevators, amusement rides, and aerial passenger tramways. • Inspecting mines, tanks, and boilers. Also, current legislation affecting the Cal/OSHA program includes unique requirements concerning cranes, construction permits,
A Brief Introduction to Important Vessel Mooring Techniques
www.marineinsight.comoperation lies with master of the ship (In case pilot is taking the lead, he will be responsible for the coordination) and not the shore/port mooring party. The port authority also plays an important role to arrange the berth and equipment for ship to get alongside which also requires moving of cranes away from the area until the
Preventing accidents during lifting operations
www.hse.gov.ukd) The lifting operation should be appropriately supervised 2) Ensure that the lifting operations are properly co-ordinated, so all trades working on site know about the operation, and not put to risk. 1) Before starting work, make sure you have been properly briefed 2) Take the time to check the lifting plan against what you actually see on site