Transcription of Throttle & Choke Control Installation & Adjustment Guide
{{id}} {{{paragraph}}}
1 Throttle & Choke ControlInstallation & Adjustment GuideContentsPage 2-3 Magnum Twin Horizontal Shaft .. 4-7 Magnum Twin Vertical Shaft .. 8-10 Command Single 11-15 Command Twin Cylinder .. 16-19 OHC Twin Cylinder .. 20-232 Safety PrecautionsElectrical Shock!Never touch electrical wires orcomponents while the engine isrunning. They can be sources ofelectrical Starts!Disabling engine. Accidentalstarting can cause severe injuryor death. Before working on theengine or equipment, disable theengine as follows: 1) Disconnectthe spark plug lead(s). 2) Removebattery cables (remove negative (-)lead first). Reconnect negative (-)lead last when reconnecting Exhaust Gases!
control back 3/16" (4.75 mm). Insert the control cable bowden wire in the proper hole of the engine control lever, which is located on the side of the carburetor air intake elbow. Engine Throttle Control Lever (Shown in Low Idle Position) Throttle Cable (Under Cable Clamp) Constant Speed Control (When Remote Cable is Not Used) Optional Throttle ...
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}