Transcription of Tightening Torques - MWRENCH
{{id}} {{{paragraph}}}
Tightening Torques 20/10/97. 00 - 1 General Instructions Type screw Dimensio Unit n 00 00 Extract from company standard BMW N 600 The maximum Tightening Torques are: Only applicable to shaft screws with metric standard and fine threads acc. to DIN 13, sheet 13 and nuts with height of 0,8 x d acc. to DIN 934 and only for a . total = (screws phosphatized, screws untreated or galvanized. Lubrication condition: unlubricated and also oiled). For cadmium-plated screws or nuts ( total = to ) the Tightening torque with screw material at the same level of utilization ca. must be 30% less than shown in the table. The values specified in this table apply to all screw connections conforming to the aforementioned conditions. Not applicable when using a different surface or lubricant condition on the thread, or if the height of the nut differs.
Only applicable to shaft screws with metric standard and fine threads acc. to DIN 13, sheet 13 and nuts with height of 0,8 x d acc. to DIN 934 and only for a µ total = 0.125 (screws phosphatized, screws untreated or galvanized.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}