Transcription of Trim Materials - ICEWeb
{{id}} {{{paragraph}}}
Sizing & Selection 10. trim Materials Valtek uses 316 stainless steel as standard plug and combination of relative hardness and corrosion resis- seat ring material except in the case of special alloy tance. For corrosion resistance , special alloys such bodies where trims are usually furnished in the same as Alloy 20, Hastelloy C and Monel are also available. material as the body. It is difficult to assign specific A major problem with material selection is deciding limitations to the use of stainless steel because of the when to apply a hard face to protect the control valve insufficient information about the actual condition of the trim . Scientific studies have not adequately predicted flowing stream. However, Valtek applies one general when hard facing should be used.
10-3 Table 10-II: Trim Material Characteristics Trim Hardness Impact Corrosion Recommended Erosion Abrasion Availability Material Rockwell C Strength Resistance Max. Temp. Resistance Resistance
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}
Relative Corrosion Resistance of Standard, Relative Corrosion Resistance of Standard Stainless Steel, JFE443CT, Stainless Steel, Corrosion Resistance, Salt spray test, Stainless, Stainless Steel Grade Selection, HANDBOOK STAINLESS, Steel, HANDBOOK Stainless Steel, High- Performance Stainless Steels, High-Performance Stainless Steels, EOS StainlessSteel PH1, RIVET HANDBOOK, Corrosion, Metallic Spring Energized Teflon* Seals