Transcription of Tuning and Log View Software User Manual
{{id}} {{{paragraph}}}
Tuning and Log View Software User ManualTable of Contents GENERAL Software USE .. 3 ICONS .. 3 COMMUNICATION MODES .. 3 CREATING AN INITIAL CALIBRATION .. 3 ADVANCED OPERATION .. 4 SAVING AND SENDING FILES .. 5 Sending a Config to the ECU .. 5 Retrieving a Config From the ECU .. 5 Saving a Config .. 5 FUEL .. 6 BASE FUEL .. 6 FUEL GRAPH .. 7 LEARN TABLE .. 7 TARGET AIR/FUEL RATIO .. 8 ACCELERATION ENRICHMENT .. 9 AE vs TPS Rate of Change .. 9 AE vs TPS RoC Blanking Value .. 9 AE TPS vs Coolant Temp .. 9 AE Correction vs TPS .. 10 AE vs MAP Rate of Change .. 10 AE vs MAP RoC Blanking Value .. 10 Map AE Time vs Coolant .. 10 Map AE vs Coolant .. 11 TEMPERATURE ENRICHMENT .. 11 Coolant Temp Enrichment.
2. Turn the ignition power on with the USB Communications cable connected. The Communication mode should say “USB Link”. 3. Mouse-click on the “USB Link” button. 4. A “sync” will be performed. If the Global Folder in the ECU is different than what is on the laptop, you will be prompted to “Get from ECU” or “Send to ECU”.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}