Transcription of Tuning and Log View Software User Manual
{{id}} {{{paragraph}}}
Example: stock market
Tuning and Log View Software User Manual
Tuning and Log View Software User ManualTable of Contents GENERAL Software USE .. 3 ICONS .. 3 COMMUNICATION MODES .. 3 CREATING AN INITIAL CALIBRATION .. 3 ADVANCED OPERATION .. 4 SAVING AND SENDING FILES .. 5 Sending a Config to the ecu .. 5 Retrieving a Config From the ecu .. 5 Saving a Config .. 5 FUEL .. 6 BASE FUEL .. 6 FUEL GRAPH .. 7 LEARN TABLE .. 7 TARGET AIR/FUEL RATIO .. 8 ACCELERATION ENRICHMENT .. 9 AE vs TPS Rate of Change .. 9 AE vs TPS RoC Blanking Value .. 9 AE TPS vs Coolant Temp .. 9 AE Correction vs TPS .. 10 AE vs MAP Rate of Change .. 10 AE vs MAP RoC Blanking Value .. 10 Map AE Time vs Coolant .. 10 Map AE vs Coolant .. 11 TEMPERATURE ENRICHMENT .. 11 Coolant Temp Enrichment .. 11 AFR Ratio Offset .. 11 Air Temp Enrichment Table .. 12 STARTUP 12 Cranking Fuel .. 13 After Start Enrichment .. 13 After Start Holdoff .. 14 After Start Decay Rate .. 14 FUEL CONTROL .. 14 Decel Fuel Cutoff .. 14 Fuel Control Decel Wait Time.
4. A “sync” will be performed. If the Global Folder in the ECU is different than what is on the laptop, you will be prompted to “Get from ECU” or “Send to ECU”. To send the current Global Folder on the laptop to the ECU, select “Send to ECU”. The file in the ECU will be over-written. The Communication mode should now read ...
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: