Transcription of UNDER-CARPET WIREWAY INSTALLATION GUIDE
{{id}} {{{paragraph}}}
Example: quiz answers
UNDER-CARPET WIREWAY INSTALLATION GUIDE
UNDER-CARPET WIREWAY INSTALLATION (02012017) WIREWAY INSTALLATION GUIDEQUESTIONS? CALL US AT ! These components are typical for each WIREWAY INSTALLATION :BOTTOM TRACKS crews to concreteAluminum - trimmed to lengthRAMPSC overed by carpetABS plastic and MDFTOP CAPS naps into bottom trackAluminum - trimmed to lengthWIRE MANAGEMENT CLIPSS ecures cabling in wirewayPOWER SYSTEMD uplex shown, Quad availableWALL BASE TRIMF inishes cable opening at wall UNDER-CARPET WIREWAY INSTALLATION (02012017) BASICSTIP!Don t cut the top cap AND CUTThe aluminum bottom track and MDF ramps are usually trimmed to whatever length you need using an aluminum-cutting saw IT DOWNNow you can screw the bottom track to the fl oor - we recommend screw one every 18 -24 .Before you start, remove all carpet from the area where you will install the Connectrac.
2.7 UNDER-CARPET WIREWAY INSTALLATION (02012017) CONNECTRAC.COM4 7 PLACE CABLING INTO WIREWAY Once the power conduit is straight, you can fasten down the device and lay the remaining cables: POWER DOWN CENTER
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: