Transcription of VDOT MATERIALS DIVISION
{{id}} {{{paragraph}}}
Example: air traffic controller
VDOT MATERIALS DIVISION
MATERIALS DIVISION MATERIALS Acceptance & Testing MATERIALS DIVISION . MATERIAL ACCEPTANCE & TESTING. THE ACCEPTANCE METHODS LISTED BELOW SHOULD ONLY BE USED AS A QUICK REFERENCE. _____. ACCEPTANCE METHODS ARE SUBJECT TO CHANGE AND THE ACCEPTANCE METHODS LISTED MAY NOT BE. APPLICABLE IN ALL CASES. PLEASE REFER TO THE MATERIALS DIVISION MANUAL OF INSTRUCTIONS FOR. CURRENT MATERIAL ACCEPTANCE METHODS. PLEASE BE GUIDED BY THE PROJECT SOURCE OF MATERIALS . A. Chance Helical Anchors SPEL List (Pending). SS is for Square shaft. HS is for hollow shaft Chance Helical Anchors Check to see if on SPEL List.
• Cert & Mill Analysis R & B Sec. 504 Sec.229 Aluminum Ladder • Cert & Mill Check special provisions Aluminum Mill • The CAST # is the same as the HEAT # Aluminum Oxide not acceptable for Steel Grit & Shot Approved List #18 Aluminum Railing spec for alloy B221 Amelia Lumber Co. Inc. Amelia, VA • Approved List #45 American Excelsior
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: