Transcription of WELL CONTROL PRINCIPLES AND PROCEDURES FOR …
{{id}} {{{paragraph}}}
Example: bachelor of science
WELL CONTROL PRINCIPLES AND PROCEDURES FOR …
well CONTROL PRINCIPLES AND PROCEDURES FOR COMPLETION, RECOMPLETION, AND WORKOVER (C,R,&W) A. INTRODUCTION Oil and gas well CONTROL PROCEDURES for C, R,& W operations are significantly different than those used when drilling. Though basic pressure considerations are the same, implementation methods vary greatly due to well conditions, which are often unique to individual wells. These conditions include the type of completion, formation pressures exposed to the wellbore, and the reasons for performing the workover. Routine C,R,& W operations often require the implementation of various well CONTROL PROCEDURES . The most common are 1) killing a producing well and 2) controlling kicks, which occur during a workover. An understanding of the differences between these two operations and the effect of routine operations on well CONTROL is essential for the workover supervisor. In this section, specific attention will be paid to pressure and its effect on well CONTROL , causes of kicks and considerations, which affect selection of proper kill PROCEDURES .
WELL CONTROL PRINCIPLES AND PROCEDURES FOR COMPLETION, RECOMPLETION, AND WORKOVER (C,R,&W) A. INTRODUCTION Oil and gas well control procedures for C, R,& W operations are significantly different t han those used when
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: