3v Low Power Half Duplex Rs

±15kV ESD-Protected, Slew-Rate-Limited, Low-Power, RS …

designed for full-duplex communications, while the MAX481E, MAX483E, MAX485E, MAX487E, and MAX1487E are designed for half-duplex applications. For applications that are not ESD sensitive see the pin-and function-compatible MAX481, MAX483, MAX485, MAX487–MAX491, and MAX1487. Applications Low-Power RS-485 Transceivers Low-Power RS-422 Transceivers

  Power, Half, Duplex, Power rs

MAX481/MAX483/MAX485/ MAX487–MAX491/MAX1487 …

MAX1487 transceivers on the bus. Full-duplex communi-cations are obtained using the MAX488–MAX491, while the MAX481, MAX483, MAX485, MAX487, and MAX1487 are designed for half-duplex applications. _____Applications Low-Power RS-485 Transceivers Low-Power RS-422 Transceivers Level Translators Transceivers for EMI-Sensitive Applications

  Power, Half, Duplex, Power rs

MAX13487E/MAX13488E Half-Duplex RS-485-/RS-422- …

MAX13487E/MAX13488E Half-Duplex RS-485-/RS-422-Compatible Transceiver with AutoDirection Control www.maximintegrated.com Maxim Integrated | 3 Electrical Characteristics (continued) (VCC = +5V ±5%, TA = TMIN to TMAX, unless otherwise noted. Typical values are at VCC = +5V and TA = +25°C.) (Note 1) PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS ...

  With, Control, Half, Transceiver, Compatible, Duplex, Duplex rs, 422 compatible transceiver with autodirection control, Autodirection

PL-2303HX Edition (Chip Rev D) USB to Serial Bridge ...

o One, one and a half, or two stop bits o Parity error, frame error, and serial break detection o Programmable baud rate from 75 bps to 12M bps o External RS232 driver power down control o Independent power source for serial interface Supports RS-422/RS-485 like serial interface (TXD, DTR_N, and RTS_N pins should be

  Power, Half

RS-485 Reference Guide (Rev. A) - TI.com

RS-485 uide 44 Texas Instruments 2014 RS-485 Reference Guide Selection Table Device TX/ RX Duplex Supply (V) Features Signaling Rate (Mbps) HBM ESD (kV) Receiver Fail-Safe Nodes Package(s)

  Rs 485 reference guide

IEEE P802.3ae MDC/MDIO

Copenhagen, Denmark Sept 17-19, 2001 May 4, 2000IEEE P802.3ae MDC/MDIO Slide – V1.03 IEEE 802.3ah Task Force Slide 3 What is MDIO for ? ‘..a simple, two -wire, serial interface to connect a management entity and a

SP339E DS - maxlinear.com

SP339E 3 REV. 1.0.6 RS-232/RS-485/RS-422 TRANSCEIVER WITH INTERNAL TERMINATION PIN DESCRIPTIONS BY MODE (MODE1, MODE0) Pin Name 00, Figure1 01, Figure2 10, Figure3 11, Figure4 1 L1 R1 Output 1 1 2 L2 R2 Output R1 Output R1 Output