A419 Series Electronic Temperature Controls with Display ...
functions. An LED indicates the controls’ output relay On/Off status. The A419 controls are available in 24 VAC or 120/240 VAC powered models. The A419 controls have heating and cooling modes, adjustable setpoint and differential, an adjustable anti-short cycle delay, and a temperature offset function. The setpoint range is -30 to 212°F
Download A419 Series Electronic Temperature Controls with Display ...
Information
Domain:
Source:
Link to this page:
Documents from same domain
MODEL YK CENTRIFUGAL LIQUID CHILLER STYLE G
cgproducts.johnsoncontrols.comFORM 160.75-EG1 (517) MODEL YK CENTRIFUGAL LIQUID CHILLER STYLE G 250 THROUGH 3000 TONS (879 through 10,500 kW) Utilizing HFC-134a Refrigerant
AIR-COOLED SCREW LIQUID CHILLERS - Johnson …
cgproducts.johnsoncontrols.comr134a ycav style a models ycav0157-0267, 60 hz (150-260 tons) e/v high efficiency and s/p standard efficiency ld10477 air-cooled screw liquid chillers
MODEL YK (STYLE E) R-134a COOLING ONLY WITH …
cgproducts.johnsoncontrols.comoperating & maintenance maxetm centrifugal liquid chillers supersedes: nothing form 160.54-o2 (1102) model yk (style e) r-134a cooling only with optiviewtm control center for electro-mechanical starter,
Section Vb1: Valves - Johnson Controls
cgproducts.johnsoncontrols.comVb1 Engineering Data Book 3 Valves The valve is a controlled device that regulates the flow of a liquid or gas in a system. This regulation is accomplished by …
G670 Intermittent Pilot Ignition Controls Technical …
cgproducts.johnsoncontrols.comG G670 Intermittent Pilot Ignition Controls Technical Bulletin 3 Figure 2 illustrates the sequence of operation for the G670 ignition control. On a call for heat from the system thermostat, the G670 simultaneously
AIR-COOLED SCREW LIQUID CHILLERS - Johnson …
cgproducts.johnsoncontrols.com2 JOHNSON CONTROLS FORM 201.21-RP1 (616) In complying with YORK's policy for continuous improvement, the information contained in this document is subjected to change without notice.
MODELS SSS 7L-B, 14L-B, 26L-B, 33L-B ... - Johnson …
cgproducts.johnsoncontrols.com2 JOHNSON CONTROLS FORM 160.00-O2 ISSUE DATE: 6/10/2011 This equipment is a relatively complicated apparatus. During installation, operation maintenance or service,
A99B Series Temperature Sensors …
cgproducts.johnsoncontrols.com2 A99B Series Temperature Sensors Product/Technical Bulletin Application Overview IMPORTANT: All A99B Series Sensors are designed for use only with operating controls. Where an operating control failure would result in personal injury and/or
System 350TM A350P Electronic Proportional Plus …
cgproducts.johnsoncontrols.comReduces inventory by encompassing temperature ranges required to support the majority of Heating, Ventilation, Air Conditioning, and Refrigeration (HVAC/R) applications
Ranco® Refrigeration Cross-Reference Catalog Page
cgproducts.johnsoncontrols.comThe performance specifications are nominal and conform to acceptable industry standards. For applications at conditions beyond these specifications, consult the local Johnson Controls office.
Related documents
Contactors and relays - Moeller
www.moeller.netclosed simultaneously. At the same time, it is necessary to ensure that the contact gaps are at least 0.5 mm over the lifespan, even when defective (e.g. when a contact is welded). The contactor relays DILER and DILA fulfil this requirement. Contactor relays DIL Two contactor relay series are available as a modular system: • Contactor relays ...
RESISTANCE WELDING BASICS
www.entroncontrols.comA relay or hand operated switch might be considered as a switching device, but either ... This is the function of the welding control; in fact, the purpose of a welding control is to coordinate the application of ... time is necessary to delay the weld current until electrode force has built up to the desired level.
Asynchronous Transfer Mode (ATM)
www.cse.wustl.eduThe reason for choosing a small size cell was mainly a result of the need to support delay-intolerant interactive voice service (e.g., phone calls) with a a small packetization delay, i.e., the time needed to fill a cell with PCM (pulse code modulation) encoded voice samples arriving at the rate of 64 Kbps.
Chapter 7 TIMERS, COUNTERS and T/C APPLICATIONS
www.eng.utoledo.eduWhile these timers are only a sampling of the types of different timers, their function describes the main function of all timers, a time delay. While PLC vendors do not need to use the terms of on-delay or off-delay, normally closed, normally open, held closed, or held open, these terms are an important part of design of PLC circuits.
700-2.17: Electronic High Performance Timing Relays
literature.rockwellautomation.com“S” is opened, the time delay begins again. After the time delay is completed, the contact returns to shelf state. 700-FSC3 Z12 700-FSC3 U23 — (D) One shot 700-FSD3KU23 The output contact changes state when the relay is energized. The output contact 700-FSD3LU23 returns to shelf state when the time delay is completed. 700-FSD3 Z12 700 ...
193-K/193-T1 Bimetallic Overload Relay Specifications
literature.rockwellautomation.comType of Relay Ambient compensated, time delay, phase loss sensitive Nature of Relay Bimetallic overload relay Trip Rating 120% FLA Trip Class IEC: 10A, UL 10 Reset Mode Automatic or manual Power dissipation up to 0.4 A 7 W 0.5…12.5 A 6 W Thermal Overload Relays Circuit Diagrams General Data 193-K Standards IEC/EN 60947-1, -4-1, -5-1, UL 508 ...
Bangladesh Labour Act, 2006
ilo.org132. Claims arising out of deductions from wages or delay in payment of wages 133. Court fees in proceeding under section 132 134. Single application in respect of a clad of workers whose wages have not been paid or wages deducted 135. Appeal 136. Conditional attachment of property of employer or other person responsible for payment of wages 137.