Camera Serial Interface - MIPI Alliance
MIPI’s Standards Today CSI-2 1.3 • D-PHY 1.2, C-PHY 1.0 or “combo PHY” is possible • 4 Virtual Channels • I2C based control interface • Line based transmission – Easy implementation – Low gate count – Matched data rates for sensor and link • In-band interrupts
Download Camera Serial Interface - MIPI Alliance
Information
Domain:
Source:
Link to this page:
Documents from same domain
Evolving CSI-2 Speci˜ cation - MIPI Alliance
www.mipi.orgThe table below illustrates optimal MIPI CSI and PHY con˝ gurations for popular 4K imaging format: TECHNOLOGY BRIEF Evolving CSI-2 Speci˜ cation CSI-2 over D-PHY and C-PHY D-PHY as used in CSI-2 is a unidirectional di˜ erential interface with one 2-wire forwarded clock lane and one or more 2-wire
Related documents
MIPI Alliance Specification for Camera Serial Interface 2 ...
caxapa.ruMIPI, MIPI Alliance and the dotted rainbow arch and all related 13 trademarks, tradenames, and other intellectual property are the exclusive property of MIPI Alliance and 14 cannot be used without its express prior written permission.
Understanding and Performing MIPI D-PHY Physical Layer ...
download.tek.comUnderstanding and Performing MIPI® D-PHY Physical Layer, CSI and DSI Protocol Layer Testing Application Note Introduction Currently many technologies are used in designing mobile or portable devices. These current interfaces are not well defined and are proprietary for each component or subsystem vendor.
Evolving CSI-2 Speci˜ cation - MIPI Alliance
www.mipi.orgThe table below illustrates optimal MIPI CSI and PHY con˝ gurations for popular 4K imaging format: TECHNOLOGY BRIEF Evolving CSI-2 Speci˜ cation CSI-2 over D-PHY and C-PHY D-PHY as used in CSI-2 is a unidirectional di˜ erential interface with one 2-wire forwarded clock lane and one or more 2-wire
MIPI–CSI2 Peripheral on i.MX6 MPUs
www.nxp.com2.2. MIPI signal CSI-2 uses the MIPI standard for the D-PHY physical layer. This document provides an overview of the MIPI signal format. For more information about the MIPI specification, see MIPI Alliance Standard for Camera Serial Interface 2 documentation at mipi.org. 2.2.1. Lanes CSI-2 is a lane-scalable specification.
i.MX 8 FAMILY OF APPLICATIONS PROCESSORS
www.nxp.com1 x MIPI DSI (4-lanes) 1 x MIPI CSI (4-lanes) 1 x MIPI CSI 1 x LVDS Tx 1 x HDMI 2.0a/eDP 1.4/DP 1.3 with HDCP 2.2 1 x HDMI 1.4 Rx with HDCP 2.2 1 x LVDS Tx 1 x MIPI DSI (4-lanes) Video: h.265 dec 4K/2K h.264 dec/enc 1080p 1 x 4-8 …
STM32MP1 Series interfacing with a MIPI® CSI-2 camera ...
www.st.comThe MIPI CSI-2.1 interface can theoretically achieve data throughput rates up to 2.5 Gbyte/s per lane with a D-PHY . This is hardly achievable on a parallel port interface due firstly to I/O slew rate pin constraints on a general-purpose device such as the STM32MP1 Series, which only have a MIPI CPI interface. ...