CODE OF PRACTICE - EMSD
Code of Practice for Fresh Water Cooling Towers Part 1: Design, Installation and Commissioning 4.1 General 16 4.2 Cooling Towers installed on Building Roof 18 4.3 Cooling Towers installed on Podium Roof 18 4.4 Cooling Towers installed indoors with Vertical Discharge through Roof or Horizontal Discharge through Side Wall 19
Download CODE OF PRACTICE - EMSD
Information
Domain:
Source:
Link to this page:
Documents from same domain
Code of Practice for the Electricity (Wiring) Regulations ...
www.emsd.gov.hkof the Wiring Regulations. However, those installations or parts of installation which comply with 2015 edition of this CoP is also deemed to have met the requirements of the Wiring Regulations provided that they: (a) completed and connected to electricity supplies before 31 …
Code of Practice for Energy Efficiency of Lighting ...
www.emsd.gov.hkThe set of comprehensive Building Energy Codes cover this Code, the Codes of Practice for Energy Efficiency of Air Conditioning Installations, Electrical Installations, and Lift & Escalator Installations, and the Performance-based Building Energy Code. Amendment to 1998 Edition
Technical Guidelines on Charging Facilities for Electric ...
www.emsd.gov.hk10. For Mode 1 charging, an AC charging current is delivered via a standard socket outlet e.g. BS1363 13A and a charging cable without communication function to the on-board charger of the EV. The presence of a residual current device (RCD) is a must on the supply side of the fixed electrical installation. This mode of charging is suitable for
Building Information Modelling for Asset Management …
www.emsd.gov.hk6 1. Introduction 1.1. Overview and Objectives The Building Information Modelling for Asset Management (BIM-AM) Standards and Guidelines is based on the asset templates developed by Electrical & Mechanical Services Department (EMSD), which is a summary of information requirement for more than 21 types of Electrical & Mechanical (E&M) systems that need …
Checklists to be Used - EMSD
www.emsd.gov.hktrunking. Bushing and rubber grommet, where necessary, provided. _____ (iii) Conductor sized to suit the rating of the fuse/MCB protecting the circuit. _____ (iv) No cable joint in final circuit. _____ (v) All joints of metal conduits or trunking to be mechanically sound, electrically continuous and protected against corrosion. _____ (vi) For ...
FORM 1 - New/Renewal Application for Registration as an ...
www.emsd.gov.hkELECTRICITY (REGISTRATION) REGULATIONS NEW/RENEWAL APPLICATION FOR REGISTRATION AS AN ELECTRICAL CONTRACTOR 此欄不用填寫 For Official use only 收件日期： Receipt date: 收據編號： Receipt Number: (注意：填寫此申請表格前請參閱「表格一備註」。
Guidance Notes for the Electrical Products (Safety ...
www.emsd.gov.hkThe Notes are a guide for suppliers of electrical products to understand the requirements of the Regulation. The Notes also set out lists of standards that are deemed to satisfy the applicable safety requirements of the Regulation. The Notes, which should be read in conjunction with the Regulation, are for guidance only and have no legal force.
Guidelines on Energy Efficiency of Lift & Escalator ...
www.emsd.gov.hkPractice for Energy Efficiency of Lighting Installations, Air Conditioning Installations and Electrical Installations, and the Performance-based Building Energy Code. As a supplement to the Lift & Escalator Code, the EMSD has developed this handbook of Guidelines on Energy Efficiency of Lift & Escalator Installations (Guidelines).
香港避雷系統與防雷裝置守則 大廈避雷系統適用標準規範 一 …
www.emsd.gov.hkIEC / BS EN 62305-1 = GB/T 21714.1 4. IEC / BS EN 62305-2 = GB/T 21714.2 5 IEC / BS EN 62305-3 = GB/T 21714.3 6. IEC / BS EN 62305-4 = GB/T 21714.4 7 8. Practice Note for Authorized Persons Buildings Department and Registered Structural Engineers 屋宇署156 ...
Guidelines s on n E n e r g y y E ffi cie n cy y o f ...
www.emsd.gov.hkBuildings was also launched. The Registration Scheme provides the certification to a building complying with one or more of the BEC. This book of Guidelines is copyrighted and all rights (including subsequent amendments) are reserved. The Building Energy Codes, corresponding Guidelines and Registration Scheme documents are
Related documents
Basic Electrical Engineering for HVAC Engineers
www.cedengineering.comHere are the basic rules of a series circuit. • Current: In a series circuit the current (I) in amperes is the same everywhere in the circuit. IT= I1 = I2 = I3 • Voltage: The total voltage of the circuit will be the sum of the voltages across each of the resistors in …