DESCRIPTION - belling.com.cn
2) Using a bypass capacitor (C ADJ) between the ADJ pin and ground can improve ripple rejection. This bypass capacitor prevents ripple from being amplified as the output voltage is increased. The impedance of C ADJ should be less than R1 to prevent ripple from being amplified. As R1 is normally in the range of 100Ω~500Ω, the value of C ADJ
Download DESCRIPTION - belling.com.cn
Information
Domain:
Source:
Link to this page:
Related documents
R Introduction to Electronics
www.ece.mtu.eduIntroduction to Electronics ii Dedication Human beings are a delightful and complex amalgam of the spiritual, the emotional, the intellectual, and the physical.
Part II How to Design and Build Working Electronic Circuits
www-mdp.eng.cam.ac.ukcomponents such as resistors, capacitors, diodes, and transistors. Then, practical circuits for power supplies, op amps, sensors, and actuators are described in detail with a special emphasis on specifying and choosing the right components. The sections that follow discuss how to program microprocessors and how to use microprocessors to
Chapter 6 FET Biasing - Khon Kaen University
home.kku.ac.thcapacitors, including the bypass capacitor C S, have been replaced by an “open-circuit” equivalent. In addition, the source V DD was separated into two equivalent sources to permit a further separation of the input and output regions of the network. KCL requires that I R1 = I R2 and the series equivalent circuit appearing to the left of the