ESDサプレッサ EZAEG タイプ - Panasonic

N ZNR-D J - industrial.panasonic.com

設計･仕様について予告なく変更する場合があります。ご購入及びご使用前に当社の技術仕様書などをお求め願い，それらに基づいて購入及び使用していただきますようお願いします。

Thick Film Chip Resistors - Panasonic

Safety Precautions (Common precautions for Fixed Resistors) • When using our products, no matter what sort of equipment they might be used for, be sure to make a written

  Resistor, Film

Thick Film Chip Resistors / Low Resistance Type

Fixed Metal (Oxide) Film Resistors mounted on your product rather than only depending on the calculated

  Resistance, Resistor, Film, Low resistance, Film resistors

Conductive Polymer Hybrid Aluminum Electrolytic Capacitors ...

S（85℃ 1000 to 2000 h) Rated voltage (V.DC) Capacitance (μF) X Product classification 3 figures Series 2 figures Voltage code 2 figures Capacitance code

  Capacitors, Aluminum, Electrolytic, Aluminum electrolytic capacitors

“PGS” Graphite Sheets - Panasonic

The temperature of this product at the time of use changes depending on mounting conditions and usage conditions, therefore, please confirm that the temperature of this product is the specified : temperature after mounting it. This product does not take the use under the following special environments into consideration.

  Temperatures, Graphite

Aluminum Electrolytic Capacitors Surface Mount Type FK …

Aluminum Electrolytic Capacitors (SMD Type) Endurance : 105 ℃ 2000 h (≧ ø12.5 : 5000 h) *1: Size code( ): Miniaturization product *2: Ripple current (100 kHz / +105 ℃） ...

  Capacitors, Aluminum, Electrolytic, Aluminum electrolytic capacitors

Aluminum Electrolytic Capacitors - Panasonic

Aluminum Electrolytic Capacitors. Radial Lead Type Endurance : 85 ℃ 2000 h Smaller than series SU RoHS compliant; Unit：mm. Frequency correction factor for ripple current. Dissipation factor（tan δ) ≦ 150 % of the initial limit

  Capacitors, Aluminum, Electrolytic, Aluminum electrolytic capacitors

AC Servo Motor and Driver˜ - Industrial Devices & Solutions

a heating unit such as a heater or a large wire wound resistor.˜ Do not place combustibles near by the motor, driver and regenera-tive resistor. Failure to observe this in-struction could result in fire and breakdowns. Ground the earth terminal of the motor and driver without fail. Failure to observe this in-struction could result in

  Industrial, Unit

AC Servo Motor and Driver˜ MINAS A4 Series˜

AC Servo Motor and Driver˜ MINAS A4 Series˜ •Thank you for buying and using Panasonic AC Servo Motor and Driver, MINAS A4 Series. •Read through this Instruction Manual for proper use, especially read "Precautions for Safety" ( P.8 to 11) without fail for safety purpose.

  Series

Aluminum Electrolytic Capacitors - Panasonic

Aluminum Electrolytic Capacitors (Radial Lead Type) Endurance : 105 ℃ 1000 h / ø4 to ø6.3, 105 ℃ 2000 h / ø8, 105 ℃ 3000 h / ø10, 105 ℃ 5000 h …

  Aluminum, Electrolytic, Aluminum electrolytic

PESD1CAN-U CAN bus ESD protection diode

ESD TESTER IEC 61000-4-2 network Cs = 150 pF; Rd = 330 Ω 4 GHz DIGITAL OSCILLOSCOPE 10x ATTENUATOR unclamped +8 kV ESD pulse waveform (IEC 61000-4-2 network) unclamped -8 kV ESD pulse waveform (IEC 61000-4-2 network) GND clamped +8 kV ESD pulse waveform (IEC 61000-4-2 network) aaa-007017 GND clamped -8 kV ESD pulse waveform (IEC 61000-4-2 network)

  Protection, Diode, Esd protection diodes, Kv esd

PESD1CAN CAN bus ESD protection diode

ESD clamping test setup and waveforms 006aaa259 50 Ω RZ CZ D.U.T. (Device Under Test) vertical scale = 200 V/div horizontal scale = 50 ns/div unclamped +1 kV ESD voltage waveform (IEC 61000-4-2 network) clamped +1 kV ESD voltage waveform (IEC 61000-4-2 network) unclamped −1 kV ESD voltage waveform (IEC 61000-4-2 network) clamped −1 kV ESD ...

  Kv esd

IP4220CZ6 Dual USB 2.0 integrated ESD protection

ElectroStatic Discharge (ESD). It incorporates four pairs of ultra low capacitance rail-to-rail ESD protection diodes plus a Zener diode to provide protection to signal and supply components from ESD voltages up to 8 kV contact discharge. Protection is supply voltage independent due to the rail-to-rail diodes being connected to the Zener diode.

  Discharge, Electrostatic, Electrostatic discharge

EdgeRouter X Datasheet

ESD/EMP Protection Air: ± 24 kV, Contact: ± 24 kV Operating Temperature -10 to 45° C (14 to 113° F) Operating Humidity 10 to 90% Noncondensing Networking Interfaces Data/PoE Output Port (5) 10/100/1000 RJ45 Ports Data Port (1) 100/1000 SFP Port PoE with 24VDC Power Adapter PoE Out Voltage Range 22‑24VDC Max. PoE Wattage Per Data/PoE ...

UniFi PoE Switch Datasheet

ESD/EMP Protection Air: ± 24 kV, Contact: ± 24 kV Shock and Vibration ETSI300-019-1.4 Standard Operating Temperature -5 to 40° C (23 to 104° F) Operating Humidity 5 to 95% Noncondensing Certifications CE, FCC, IC

  Datasheet

ESDサプレッサ EZAEG タイプ EZAEG 1N, 2N シリーズ

esd耐量が大きい (iec61000-4-2, 15 kv接触／気中放電) 高速伝送ラインのesd対策部品に適している 静電容量が低い (1005サイズ：0.05 pf、 0603サイズ：0.04 pf)

Description Pin Assignments - Diodes Incorporated

ESD HBM Human Body Model ESD Protection 2 KV ESD CDM Charged Device Model ESD Protection 1 KV ESD MM Machine Model ESD Protection 200 V V. CC (A), V. CC (B) Supply Voltage Range -0.5 to +6.5 V V. I. Input Voltage Range -0.5 to +6.5 . V : V. O. Voltage Applied to Output in High Impedance or I.

  Descriptions, Kv esd

FSA2567 - Low-Power, Dual SIM Card Analog Switch

ESD Human Body Model, JEDEC: JESD22−A114 All Pins − 3 kV I/O to GND − 12 Charged Device Model, JEDEC: JESD22−C101 − 2 Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality should not be assumed, damage may occur and reliability may be affected. 1.

SRV05-4 ESD Protection Diode Array - ON Semiconductor

for ESD Devices. ESD Voltage Clamping For sensitive circuit elements it is important to limit the voltage that an IC will be exposed to during an ESD event to as low a voltage as possible. The ESD clamping voltage is the voltage drop across the ESD protection diode during an ESD event per the IEC61000−4−2 waveform. Since the

TXS0108E 8-Bit Bi-directional, Level-Shifting, Voltage ...

• IEC 61000-4-2 ESD (B port) – ±8 kV contact discharge – ±6 kV Air-gap discharge 2 Applications • Handsets • Smartphones • Tablets • Desktop PCs 3 Description This device is an 8-bit non-inverting level translator that uses two separate configurable power-supply rails.