Features
Pressure Switch 5400928 - REV E 2/20 PAGE 1 OF 4 ... also suitable to provide a low pressure supervisory signal; adjustable between 4 and 15 psi (0,27 and 1,03 bar). 1. Apply Teflon tape to the threaded male connection on the device. (Do not use pipe dope) 2. Device should be mounted in the upright position (threaded connection
Download Features
Information
Domain:
Source:
Link to this page:
Documents from same domain
SH-120 SERIES - Potter Electric Signal Company, LLC
www.pottersignal.comMKT. #8910015 - REV B 7/10 PRINTED IN USA PAGE 1 OF 2 SH-120 SERIES WALL MOUNT WEATHER PROOF SELECT-A-STROBE/HORN® Potter Electric Signal Co., LLC • St. Louis, MO • Cust Service: 866-240-1870 • Tech Support:866-956-1211• Canada 888-882-1833 • www.pottersignal.com
Features - Potter Electric Signal Company, LLC
www.pottersignal.comPAGE 3 OF 4 otter lectric Signal Compan, LLC • St Louis, • one -2- • wwwpottersignalcom 24 24 eletale andela toe ontoes 4-RV C S-24 24 VDC Selectable Candela, Low Profile Evacuation Strobe
ODC-59 SERIES - Potter Electric Signal Company, LLC
www.pottersignal.comODC-59 SERIES OVERHEAD DOOR CONTACT Potter Electric Signal Co., LLC • St. Louis, MO • Cust Service: 866-240-1870 • Tech Support: 866-956-1211 • Canada 888-882-1833 • www.pottersignal.com
Advanced Fire Training Manual - Potter Electric: Fire ...
www.pottersignal.comThe first standards for fire detection and alarm systems in the United States dates back to the 1800s. While these first fire alarms were simplistic, advances in technology have resulted in fire alarm systems that can be intimidating in their complexity.
Features
www.pottersignal.com5 in-lbs minimum to hold the trip rod in place and properly seal the enclosure. NOTE: If trip rod length is excessive, loosen the locking screw and remove the trip rod from the trip lever. Using pliers, break off the one (1) inch long notched section (see Fig. 10). Reinstall trip rod and repeat Step 3 procedure. 4.
PFC-4064 Conventional Fire Alarm Panel
www.pottersignal.comThe PFC-4064 Conventional Fire Panel is a compact, expandable panel designed to monitor all facets of a fire alarm system and communicate the status to a monitoring station. The PFC-4064 panel is a listed and approved microprocessor based conventional fire panel and complies with UL-864, NFPA-70, and NFPA-72.
VSR - pottersignal.com
www.pottersignal.com10 mAmps min. at 24VDC Conduit Entrances: Two knockouts provided for 1/2" conduit. Individual switch compartments suitable for dissimilar voltages. Environmental Specifications: • NEMA 4/IP54 Rated Enclosure suitable for indoor or outdoor use with factory installed gasket and die-cast housing when used with appropriate conduit fitting.
PFC-4410RC Installation, Operation, and Instruction Manual
www.pottersignal.comThis manual is designed to help with the specification, installation, and programming of the PFC-4410RC Release Panel. ... the design and layout of fire alarm and/or suppression systems for special hazard locations. The system shall be designed ... The PFC-4410RC complies with UL Standard 864, ULC S527, Canadian Electrical Code Part 1 C22.1 ...
SELECTABLE CANDELA CEILING MOUNT
www.pottersignal.comThe Potter CS/CHS Series is a ceiling mount strobe or horn/strobe combination that offers dependable audible and visual alarms and the lowest current consumption. The CS/CHS offers tamperproof field selectable candela options of 15, 30, 75, 95, 115 and 150 candela. The CHS horn offers a continuous or synchable temporal three in
Features
www.pottersignal.com1000E has space to allow the installation of up to six PAD100-SLCE SLC loop expansion cards. The cards mount on a stacker bracket that allows access to all SLC circuit connections. Technical Specifications Features • 1,270 addresses available on this analog addressable system • Additional system capacity achieved via multi-point SLC modules
Related documents
WEEKLY FIRE PUMP INSPECTION & TEST PROCEDURES
paragonconsults.comsupervisory signals were received by the alarm monitoring facility. ... • Check to make sure the transfer switch pilot light is illuminated ... • Record the pressure at which the pump automatically started. • Record the pump suction and discharge pressures.
DOUBLE INTERLOCK, PREACTION SYSTEM - HD Fire
www.hdfire.comValve from the system air pressure. Riser Check Valve provides an air check so that the system can be automatically pressurized with a supervisory air or nitrogen pressure of 42 PSI (2.94 Bar). A supervisory low pressure alarm switch can be set at 20 PSI (1.40 Bar), on decreasing pressure, to indicate whether