Fusing Currents in Traces - UltraCAD

When sufficient heat is applied to a copper trace (or indeed, any material) to melt the trace, there are two times that need to be considered.

Current, Trace, Fusing, Fusing currents in traces

Download Fusing Currents in Traces - UltraCAD

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Other abuse

Documents from same domain

Propagation Times and Critical Length How They …

www.ultracad.com

Propagation Times and Critical Length How They Interrelate 1 In a recent article I drew an analogy between signal reflections on electrical traces and echoes in a

Critical, Time, Propagation, They, Length, Propagation times and critical length how they, Propagation times and critical length how they interrelate, Interrelate

UltraCAD

www.ultracad.com

Introduction It’s no news that the band pass requirements for power sy s-tems on PCB’s are increasing and that power supply impe d-ance requirements are getting tighter.

Ultracad

Microstrip Propagation Times Slower Than We Think

www.ultracad.com

Microstrip Propagation Times Slower Than We Think 2 Case (b) illustrates the same trace, but with a thinner spacing between the trace and plane.

Than, Time, Propagation, Microstrip, Microstrip propagation times slower than, Slower

Differential Impedance - UltraCAD

www.ultracad.com

Differential impedance: Assume for a moment that we have terminated both traces in a resister to ground. Since i1 = -i2, there would be no current at all through ground. . Therefore, there is

Differential, Impedance, Differential impedance

Current Carrying Capacity of Vias - UltraCAD

www.ultracad.com

We are frequently asked about the current carrying capacity of vias. To our knowledge, there have been no studies of this particular topic, although we do know of peo-

Current, Capacity, Avis, Carrying, Ultracad, Current carrying capacity of vias

Transmission Line Terminations - UltraCAD

www.ultracad.com

Transmission Line Terminations It’s The End That Counts! 2 driver. If the trace is shorted, the reflection coefficient is –1 and there will be a 100% reflection of the opposite sign back toward the driver. If the line is terminated with a resistor whose value is the same as the characteristic impedance of the trace (Zo), the reflection coefficient …

Line, Transmissions, Termination, Reflections, Transmission line terminations

Differential Trace Design Rules - UltraCAD Design, …

www.ultracad.com

Differential Trace Design Rules Truth vs Fiction 2 Equal length rules, part 2: The square wave in Figure 3 has been generated in MathCad using a Fourier

Rules, Design, Differential, Trace, Differential trace design rules