GM LS Engine Gauges Installation Guide - Autometer
drilling. You may drill on the rounded portion of this plate, and using a center punch will help to get the drill bit started where you want it. • Drill straight through the component with a 5/16” drill bit. • Use a 1/8”NPT pipe tap through the newly drilled hole. • Blow out your shavings, then thread the sender, or line fitting in.
Download GM LS Engine Gauges Installation Guide - Autometer
Information
Domain:
Source:
Link to this page:
Documents from same domain
INSTALLATION INSTRUCTIONS DIGITAL FUEL LEVEL
www.autometer.comINSTALLATION INSTRUCTIONS DIGITAL FUEL LEVEL ... If after completely reading these instructions you have questions regarding the operation or installation of your instrument(s), ... The fuel level gauge can be custom calibrated to accurately display the output from any fuel …
INSTALLATION INSTRUCTIONS MECHANICAL GAUGES
www.autometer.comINSTALLATION INSTRUCTIONS MECHANICAL GAUGES 2650-1606-00 Rev. B OVER-TIGHTENING OF VENT SCREW WILL ... Toward Gauge After Installation ... If pressure gauge is used in a fuel application, the gauge must be mounted outside of the vehicle. This will prevent
INSTALLATION INSTRUCTIONS GPS SPEEDOMETER …
www.autometer.comMagnetic GPS Antenna SMA Antenna Connector Speed Signal to Speedometer Switched 12V Connection Good Engine Ground Black Violet Red Fuse (see caution below)
INSTALLATION INSTRUCTIONS ELECTRIC SPEEDOMETER
www.autometer.comTo calibrate your electronic speedometer: 1) With the power off, push and hold the calibration button (trip/reset button when equipped). While holding the button, start the vehicle and continue to hold the button until the pointer sweeps to full scale and stays at full scale. You may now release the button.
Related documents
STEEL CONSTRUCTION MANUAL - New York State …
www.dot.ny.govNEW YORK STATE STEEL CONSTRUCTION MANUAL 4TH EDITION ANDREW M. CUOMO GOVERNOR PAUL KARAS ACTING COMMISSIONER Department of Transportation, Office of Structures January 2018
FUNDAMENTALS OF WELDING - University of Technology, …
www.uotechnology.edu.iqalterations (e.g., drilling of holes) and addition of fasteners (e.g., rivets or bolts). The resulting mechanical assembly is usually heavier than a corresponding weldment. 4- Welding is not restricted to the factory environment. It can be accomplished ‘‘in the field.’’ ... The defects can reduce the strength of the joint.
94/25/EC as amended by Directive 2003/44/EC Propulsion ...
dmna.ny.govknown to the state of California to cause cancer, birth defects or other reproductive harm. Warranty Message The product you have purchased comes with a limited warranty from Mercury Marine. The terms of the warranty are set forth in the Warranty Information section of …
Control of exposure to silica dust - HSE
www.hse.gov.ukControl of exposure to silica dust: A guide for employees Page 3 of 5 Health and Safety Executive where necessary, provide you with personal protective equipment; maintain all equipment used as control measures in good working order; instruct and train you to use equipment properly, and tell you about health risks; monitor to ensure that controls are …
Owner’s Manual & Safety Instructions
manuals.harborfreight.comof California to cause cancer and birth defects or other reproductive harm. (California Health & Safety Code § 25249.5, et seq.) 9. The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense