HARDIPLANK Installation Instructions
NOTE: Some Building Codes exempt the use of weather-resistive barriers over “water-repellent panel sheathing” or exterior panels classified as “weather-resistive barriers”. James Hardie recommends the use of “building paper type” weather-resistive barriers with all siding products. James Hardie will assume no responsibility
Download HARDIPLANK Installation Instructions
Information
Domain:
Source:
Link to this page:
Documents from same domain
Section 504: Clothes Dryer Exhaust: 504.1 Installation.
www.structuretech1.comSection 504: Clothes Dryer Exhaust: 504.1 Installation. Clothes dryers shall be exhausted in accordance with the manufacturer’s instructions.
HARDIPLANK Installation Instructions
www.structuretech1.comMinimum overlap for Both Face and Blind Nailing min. 1 1/4” overlap weather-resistive barrier * nominal 2” x 2” wood furring 1” - 2” flashing
Early History of Attic Ventilation - Structure Tech Home ...
www.structuretech1.com1 Early History of Attic Ventilation William B. Rose Research Architect Building Research Council-School of Architecture University of Illinois at Urbana-Champaign
Table 501.3.3(2) Procedure to Determine Makeup Air ...
www.structuretech1.com16 Table 501.3.3(2) Procedure to Determine Makeup Air Quantity for Exhaust Equipment in Dwellings (Refer to Item 5 in Section 501.3.3 to determine applicability of this table)
HARDIPLANK Installation Instructions
www.structuretech1.com†For application over foam insulation, the length of the specified fastener ... FAILURE TO ADHERE TO WARNINGS, MSDS, AND INSTALLATION INSTRUCTIONS MAY LEAD TO SERIOUS PERSONAL INJURY. ... These documents should also be consulted for additional information concerning the suitability of this product for specific applications. JH91513SL 06/01
Related documents
TECHNICAL GUIDE - Georgia-Pacific Building Products
www.buildgp.comDensGlass Sheathing is the ideal substrate for a wide variety of air and water-resistive barriers including building wraps, fluid applied coatings, self-adhering membranes and spray foam applications. See page 10 for details. Easy to Handle DensGlass Sheathing is lightweight and easy to handle. It can be cut and fastened with standard drywall ...
Fire Sprinkler Guide to Fire Sprinklers in the ...
nfsa.orgbarriers in high-rise buildings where sprinklers are installed at the top of the shaft and alternate floor levels. 403.2.1.2– NFPA 13 . High-Rise Buildings Sprinklers reduce generator fuel line protection to 1-hour. 403.4.8.2– NFPA 13 . Atrium Floor Areas Sprinklers permit the atrium floor area to be used for any approved use where the
DUPONT TYVEK COMMERCIALWRAP AND …
www.hllmark.comPermeable Flexible Sheet Water-resistive Barriers intended for mechanical attachment • ASTM E96-00 Standard Test Methods for Water Vapor Transmission of Materials; Water resistive barriers are typically vapor permeable, which is generally desirable because it allows for drying of incidental moisture intrusion into the wall assembly
EXTERIOR FINISHES - Nudura
www.nudura.comadditional air barrier to be installed on the exterior building face as either a water resistive barrier or second defense air barrier, materials that are acceptable for use with the NUDURA Integrated Building Technology MUST NOT BE ... These materials are tested and approved air barriers designed for use where needed within the building envelope.
A GUIDE TO CREATING BUILDING CODE COMPLIANT …
floridapoly.eduIdentify weather barriers Provide window and door flashing details 7. Materials – Identification of materials used in the project Provide submittals as required by the jurisdiction for wood, steel, aluminum, concrete, plastic, glass, masonry, gypsum, roofing and insulation