High-Performance, High-Movement, Single-Component ...
Application Temperature 40 to 100 °F (4 to 37 °C) * Smoke Development ASTM E84 5 Fire Spread ASTM E84 5 Fire Resistance of Assembly NFPA 285 PASS Smoke Development CAN S102 10 Fire Spread CAN S102 10 Crack Bridging ASTM C1305 PASS Nail Sealability ASTM D1970 Section 7.9 PASS
Performance, High, Section, Component, Single, Movement, High movement, Single component
Download High-Performance, High-Movement, Single-Component ...
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Advertisement
Documents from same domain
TREMDrain® DPI - Tremco Sealants
www.tremcosealants.comTREMDrain® DPI Drainage and Protection Board Product Description TREMDrain® DPI is an optional drainage, protection and insulation board designed for use primarily with TREMproof® 260 Spray-Applied
SAFETY DATA SHEET - Tremco Sealants
www.tremcosealants.comSAFETY DATA SHEET 1. Identification ... Do not handle until all safety ... Total dust. PEL 15 mg/m3 US.
Tremco® 440 Tape - Tremco Sealants
www.tremcosealants.comTremco® 440 Tape Butyl Sealant Tape www.tremcosealants.com Page 1 of 2 Product Description Tremco® 440 Tape is a 100% solid polyisobutylene cross-linked butyl, preformed sealant.
TREMstop® Acrylic - Tremco Sealants
www.tremcosealants.comTREMstop® Acrylic An Acrylic Latex Firestop Sealant Page www.tremcosealants.com 1 of 4 Product Description • TREMstop® Acrylic is a gunnable acrylic latex sealant designed for use in
System No. C-AJ-7044 - Tremco Sealants
www.tremcosealants.comReprinted from the Online Certifications Directory with permission from Underwriters Laboratories Inc. Copyright © 2008 Underwriters Laboratories Inc. ®
System, Laboratories, Directory, Online, Certifications, 7404, Underwriters laboratories, Underwriters, System no, C aj 7044, Online certifications directory
Technical Service Bulletin - Tremco Sealants
www.tremcosealants.comIntegrated Technical Solutions . Technical Service Bulletin . Tremco ExoAir air barrier membrane gap bridging and joint movement considerations . The purpose of this bulletin is to assist design professionals and contractors in selecting the best materials
Proglaze® - Tremco Sealants
www.tremcosealants.comProglaze® Single-Component, Moisture-Cure, Acetoxy Silicone Sealant for Glazing Page www.tremcosealants.com 1 of 2 Product Description Proglaze® is a single-component, moisture-cure, acetoxy, silicone sealant for
Spectrem® 2 - Tremco Sealants
www.tremcosealants.comSpectrem® 2 Single-Component, Neutral-Cure Silicone Sealant for 2-Sided Structural Glazing Page www.tremcosealants.com 1 of 3 Product Description Spectrem® 2 is a high-performance, single-component, neutral-cure,
SEALANT SELECTION GUIDE
www.tremcosealants.comThe Sealant Selection Guide should only be used as a guide. Reference the Data Sheet for more specific information and/or consult your local Tremco Representative or Technical Services. * Modified ASTM C719 ** Willseal 600 can be used in non-immersed applications where there is no ponding water and as a backer rod on horizontal joints.
Single-Component, Rapid Curing, Fluid-Applied Elastomeric ...
www.tremcosealants.comSINGLE LIFT SYSTEM TREMproof 250GC may be applied in a single pass up to 120 mils for horizontal applications. Apply at a rate of 13 ft²/gal (0.32 M²/L.) 6.3 Multi-lift 215-mil system Apply the first coat of TREMproof 250GC at a rate of 18 ft²/gal (0.44 M²/L), to yield 90 mils. Allow the TREMproof 250GC to cure to a firm
Related documents
L DOW IQUID EPOXY RESINS - Science | Engineering
nmt.edutooling, encapsulation, adhesives, lami-nates, and coatings. Similar commercial success has been earned by the families of D.E.R. solid and solution epoxy resins, flexible epoxy resins, brominated epoxy resins, D.E.N.* epoxy novolac resins, and D.E.H.* epoxy curing agents … also produced and marketed by Dow. And since these products are used with
ANGUS Chemie GmbH Technical Data Sheet
chemical-centre.comThe resins and coatings cleared under Section 175.300 have been cleared by cross reference for use as provided in the following sections: Section 175.380 Xylene-formaldehyde resins condensed with 4,4’- isopropylidenediphenol-epichlorohydrin epoxy resins Section 175.390 Zinc-silicon dioxide matrix coatings Section 177.1210Closures with sealing ...
Intergard 269 - AkzoNobel
marinecoatings.brand.akzonobel.comMar 11, 2016 · 20 lt 16 lt 20 lt 4 lt 5 lt 5 US gal 4 US gal 5 US gal 1 US gal 1 US gal UNIT SHIPPING WEIGHT (TYPICAL) Unit Size Unit Weight 20 lt 32.9 Kg 5 US gal 68.4 lb Shelf Life 12 months minimum at 25°C. Subject to re-inspection thereafter. Store in dry, shaded conditions away from sources of heat and ignition. STORAGE EGA042-Light Grey available in ...
FRP PIPE, DUCT AND FITTINGS ENGINEERING GUIDE AND ...
mascottec.comSection 3: Pipe and Duct Filament Wound Pressure Pipe ˇ ˘ " ^ ˛ ˛ ˜ ˘˚ be furnished in the following standard lengths: 2 in. Dia through 4 in. Dia - 20 ft lengths 6 in. Dia through 54 in. Dia - 40 ft lengths 60 in. Dia and larger - 20 ft, 30 ft, or 40 ft lengths (depending on tooling) ! " " ; " + ˜ ^ ˛ ˚
BURNDY Products Grounding TABLE OF CONTENTS
www.cesco.complus 1/2 , 5/8 , 3/4 , and 1 ground rods and rebar. Inventories are kept to a minimum and product selection is simplified. • System engineered tooling. Each tooling recommendation has been designed to ensure reliability of the connection. • Irreversible compression connectors can be installed in all kinds of weather.
RECOIL Technical Catalogue
www.recoil.in4. SET TOOL: Place insert on installation tool, positioning the adjustable top so that the insert tang is centered in the tang slot. 5. INSTALL: Wind insert in with light downward pressure until 1/4 to 1/2 turn below the surface. 6. TANG REMOVAL: Do not attempt to twist tang off with tool. Lift tool from tang, turn tool 90° and tap down ...
Repair, Restoration, Replacement, and Re-creation of ...
www1.nyc.govThis section explains and illustrates the rules and criteria for the most common types of work involving repair, restoration, replacement, and re-creation of building facades and related exterior elements. See LPC Rules, Section 2-11, for more information. Section B LPC Rules and Criteria This is how the Landmarks Preservation Commission works: