Installation Guide
A class 3 self-tapping wing-tipped screw for fastening to 0.5mm to 1.6mm BMT light gauge steel frames. 1000 per box. Part No. 305984 COMPONENTS NOT SUPPLIED BY JAMES HARDIE James Hardie recommends the following products for use in conjunction with its Scyon™ Linea™ weatherboard and Scyon™ Axent™ trim.
Download Installation Guide
Information
Domain:
Source:
Link to this page:
Documents from same domain
EXTERIORS - static-content-prod.jameshardie-digital.com.au
static-content-prod.jameshardie-digital.com.auSCOPE This Installation Guide covers the use of Scyon™ Secura™ Exterior flooring sheets in a tiled residential deck application. It does not contain all information relevant for constructing a deck.
Axon Cladding Installation Guide
static-content-prod.jameshardie-digital.com.aucladding in a residential facade application over a seasoned timber wall frame or a light-gauge steel frame. DESIGN General All design and construction must comply with the appropriate requirements of the current National Construction Code (NCC) and other applicable regulations and standards. Responsibility
INTERIORS - static-content-prod.jameshardie-digital.com.au
static-content-prod.jameshardie-digital.com.auTABLE 2 PRODUCT / ACCESSORIES / TOOLS COMPONENTS SUPPLIED BY JAMES HARDIE PRODUCT DESCRIPTION PRODUCT DESCRIPTION HardieBladeTM Saw Blade. 185mm diameter A poly-diamond blade for fast and clean cutting of James Hardie™ fibre cement. Bore diameter is 20mm. 1 each. Part No. 300660 James Hardie™ Base Coat 4kg tub
Related documents
DFMA = Design for Assembly + Manufacturing
s3.cnccookbook.comtapping including: – Minimize the threaded length in the hole. 1.5x the major diameter often provides sufficient strength. – Avoid blind holes where possible. If you must thread a blind hole, allow room at the bottom of the hole for 1/2 major diameter more than the threads. – Don’t over-specify the thread percentage.
THREAD CUTTING & FORMING
users.encs.concordia.caChipless Tapping-A fluteless tap is used for Ø < ½” => cold formed in holes in ductile metals only-The required forming torque is twice the cutting torque that is necessary to cut the section.-They produce better accuracy than the fluted ones-The diameter of the hole must be well controlled-Lubricants (water soluble soaps ) are essential
Chapter 5 Installing Balusters - Bayer Built
www.bayerbuilt.combaluster firmly into the hole. 2. Next, place a small drop of glue on the top of the baluster and slide the angle cut of the baluster into the plowed portion of the rail. 2. On the previously marked intersecting lines of the baluster, drill a hole about 1-inch deep with a brad point bit of the appropriate diameter.
Table of Contents
www.stanleyengineeredfastening.comHole Sizes for Cut Tapping 23 Hole Sizes for Cold Forming 24 Tap and Gage Part Numbers - English 25 Tap and Gage Part Numbers - Fractional 26 Tap and Gage Part Numbers - Metric 28 Gaging Recommended Gaging Practices 31 Standard Tap Dimensions 32 Tapping Troubleshooting 34 Application Profile 36 ...
Machining Guide for Engineering Plastics
www.theplasticshop.co.ukapplied, especially when hole depths are more than twice the diameter. In order to improve heat and swarf removal, frequent pull-outs (peck drilling) are necessary, especially for deep holes (pull-out the drill every time a depth ≈1.5 x the diameter is attained). For large diameter holes, it is advisable to use drills with a