LTE Attach and Default Bearer Setup Messaging
maximum bit rate for the default PDP context • The second occurrence specifies the data maximum data limit via the APN. These limits are specified by the PDN • APN configuration also includes: • IP address of the PDN Gateway. This address is used to determine the default route for the traffic towards the Internet
Download LTE Attach and Default Bearer Setup Messaging
Information
Domain:
Source:
Link to this page:
Documents from same domain
DHCP sequence diagram with message details
eventhelix.comDHCP sequence diagram with message details This message flow shows how a computer boots up and obtains an IP address. The DHCP Discover and the DHCP Request handshakes are covered here. (Click on any message in the sequence diagram to see full field level details).
LTE Attach and Default Bearer Setup - EventHelix.com
eventhelix.comLTE Attach and Default Bearer Setup lte-attach.pdf Cell New E-UTRAN New EPC Old EPC Databases UE eNodeB New MME Serving GW PDN GW Old MME HSS 39:Update Bearer Request EPS Bearer Identity, eNodeB address, eNodeB TEID Upon reception of both, the Initial Context Response message and the Attach Complete message, the new MME sends an
S1AP View of LTE Attach & EPS Bearer Setup
eventhelix.com.... .010 = Attach result: Combined EPS/IMSI attach (2), NAS EPS session management messages: Activate default EPS bearer context request (0xc1), Quality of Service Class Identifier (QCI): QCI 9 (9), APN: nxtgenphone, PDN IPv4: 192.168.3.129 (192.168.3.129), Protocol or Container ID: Internet Protocol Control Protocol (0x8021),
LTE RRC Connection Setup Messaging - EventHelix.com
eventhelix.comRRC Connection Setup message • “Dedicated Info NAS” is used to transfer UE specific NAS layer information between the network and the UE. The RRC layer is transparent for this information. • The message may optionally contain registered MME • The RRC Connection Setup Complete may also carry octets for a NAS message
LTE Random Access Procedure - EventHelix.com
eventhelix.comLTE Random Access Procedure LTE random access procedure is used by the UEs to initiate a data transfer. The UEs also obtain uplink timing information from the initial handshake. This sequence diagram describes the tale of three UEs (UE …
Related documents
GPRS: How it works - O2
www.o2.co.ukPDP Context Activation Process. 9 GPRS provides two additional, independent, procedures that enable a PDP context to be deactivated and the MS to disassociate itself from the network (i.e. detach). An implicit context deactivation takes place if the MS invokes the detach procedure. GPRS detach may be
AT Commands Examples - U-blox
www.u-blox.comAT Commands Examples Examples for u-blox cellular modules Application Note Abstract This document provides detailed examples of how to use AT commands with u-blox cellular