ROUGH-IN INSPECTION CHECKLIST
bey ond the m anufacturer s installation guide. Truss m em bers shall not be altered in any way without the approval of a design professional. Truss design drawings shall be provided at tim e of inspection. Use ‚hurricane clips€and room tie-downs as specified per m anufacturer or as required per Table R802.11. (R5 02.8.2, R5 02.11, R802.10.1)
Download ROUGH-IN INSPECTION CHECKLIST
Information
Domain:
Source:
Link to this page:
Documents from same domain
Residential Deck Drawings - biupa.com
www.biupa.comGalvanized metal connector (typ.) @ top of all stringers) Risers shall not allow a 4" dia. object to pass through. 4x4 guardrail support post (typ.)
FOOTING INSPECTION CHECKLIST - Building …
www.biupa.comFOOTING INSPECTION CHECKLIST No mud or water is allowed in the footing. The builder is responsible for the job and is required to call and cancel
Related documents
Chemical Resistance Guide - Gilson Eng
www.gilsoneng.compressure and 82°C (180°F) in drainage. With a design stress of 2,000 psi, PVC has the highest long-term hydrostatic strength 22.7°C (73°F) of any other major thermoplastic material used for piping. PVC piping is joined by solvent cementing, thread-ing, flanging, grooving, gasketed joints, or …
Design Guide - Sub-Zero
www.subzero-wolf.comfor this application. Installation must comply with all applicable plumbing codes. PLUMBING REQUIREMENTS Water Supply 1/4" OD copper, braided stainless steel, or PEX tubing Pressure 35–120 psi (2.4–8.3 bar) Excess Line for Connection 36" (914) Electrical Requirements The electrical supply should be located within the shaded
Chemical Resistance Guide - Gilson Eng
www.gilsoneng.compressure and 82°C (180°F) in drainage. With a design stress of 2,000 psi, PVC has the highest long-term hydrostatic strength 22.7°C (73°F) of any other major thermoplastic material used for piping. PVC piping is joined by solvent cementing, thread-ing, flanging, grooving, gasketed joints, or mechanical joints. CPVC
Design & Installation Manual - Radiant Company
www.radiantcompany.comThe 7/8” Durapoly XL PEX is a large diameter tubing with the same wall thickness as the commonly used 1/2” PEX. It’s main advantage over 1/2” PEX lies in the fact that it holds more fluid, and consequently, more heat. It has a slightly lower temperature and pressure rating than 1/2” PEX, but it can be spaced as far apart as 16”
DOMESTIC HOT AND COLD WATER SUPPLY AND CENTRAL …
www.bpfpipesgroup.comThe Plumbing Engineering Services Design Guide, CIPHE. Safe water in healthcare premises (HTM 04-01). Always refer to the latest editions of these documents. MODULAR DESIGN Many manufacturers supply manifolds for use in heating systems. These provide an opportunity for modular system design.
DESIGNER REFRIGERATION INSTALLATION GUIDE
www.subzero-wolf.comapplication. WATER SUPPLY LOCATION A 18" Model 3" (76) 24" Model 51/2" (140) 30" Model 6" (152) 36" Model 9" (229) 3" (76) 6" (152) RIGHT SIDE OF OPENING AREA EXTENDS 1/2" (13) FORWARD ON FLOOR A Water supply location SITE PREPARATION PLUMBING REQUIREMENTS Water Supply Line 1/4" OD copper, braided stainless steel, or PEX tubing …