SAFETY DATA SHEET - MSDS
quaternary ammonium compounds, benzyl-C8-18-alkyldimethyl, chlorides ≤1.8 68424-85-1 Ingredient name CAS number Other Non-hazardous ingredients to 100% Substance/mixture : Occupational exposure limits, if available, are listed in Section 8. Mixture % (w/w) Wash out mouth with water. Remove dentures if any. Remove victim to fresh air
Download SAFETY DATA SHEET - MSDS
Information
Domain:
Source:
Link to this page:
Documents from same domain
SAFETY DATA SHEET - rb-msds.com.au
www.rb-msds.com.auPine O Cleen Disinfectant 1. Identification of the material and supplier SAFETY DATA SHEET Product name Pine O Cleen Disinfectant: SDS no. : Names Material uses : Surface Disinfectant.
SAFETY DATA SHEET - rb-msds.com.au
www.rb-msds.com.auHarpic Active Fresh Liquid 1. Identification of the material and supplier SAFETY DATA SHEET Product name Harpic Active Fresh Liquid: SDS no. : Names
SAFETY DATA SHEET - rb-msds.com.au
www.rb-msds.com.auMortein Fast Knockdown Multi Insect Killer Aerosol 1. Identification of the material and supplier SAFETY DATA SHEET Product name Mortein Fast Knockdown …
SAFETY DATA SHEET - rb-msds.com.au
www.rb-msds.com.auDettol Antiseptic Disinfectant (Liquid) 1. Identification of the material and supplier SAFETY DATA SHEET Product name Dettol Antiseptic Disinfectant (Liquid)
Glen 20 All In One Spray Disinfectant Aerosol All Scents ...
www.rb-msds.com.auGlen 20 All in One Spray Disinfectant - All Scents 1. Identification of the material and supplier SAFETY DATA SHEET Product name : ... drinking and smoking should be prohibited in areas where this material is handled, stored and processed. ... be worn at all times when handling chemical products if a risk assessment indicates
Related documents
100 Ohm Platinum RTD - 0.00385 coefficient, degree …
www.pyromation.comTABLE 30 100 Ω Platinum RTD 0.003 85 coefficient temperature in °F °F 0 1 2 3 4 5 6 7 8 9 10 °F Resistance in Ohms °F 0 1 2 3 4 5 6 7 8 9 10 °F 114 Pt°F 150 ...
Sharp-crested weirs - WUR
www2.alterra.wur.nlFor water at ordinary temperature, i.e. 5°C to 30°C (or 40°F to 85°F) the effective coefficient of discharge (Ce) for a V-notch sharp-crested weir is a function of three variables value of Kh in millimetres value of notch angle 0 in degrees Figure 5.8 …
INCONEL alloy 601 - Web - June 2008
www.specialmetals.comthe quartz specimen holder. Each coefficient listed is the average coefficient over the indicated temperature range. The effect of temperature on the modulus of elasticity of alloy 601 is shown in Table 4. The data were obtained by the dynamic method. The values listed for Poisson's ratio were calculated from moduli of elasticity.