Standard Test Methods for Deep Foundations Under Static ...
2.1 ASTM Standards: 2 D 653 Terminology Relating to Soil, Rock, and Contained Fluids D 3740 Practice for Minimum Requirements for Agencies 1 This test method is under the jurisdiction ofASTM Committee D18 on Soil and Rock and is the direct responsibility of Subcommittee D18.11 on Deep Foundations. Current edition approved Feb. 1, 2007 ...
Download Standard Test Methods for Deep Foundations Under Static ...
Information
Domain:
Source:
Link to this page:
Documents from same domain
Standard Test Methods for Deep Foundations Under Static ...
www.centurionfondation.comDesignation: D3689 – 07 Standard Test Methods for Deep Foundations Under Static Axial Tensile Load1 This standard is issued under the fixed designation D3689; the number immediately following the designation indicates the year of
Standard Test Methods for Deep Foundations Under Lateral …
www.centurionfondation.comDesignation: D3966 – 07 Standard Test Methods for Deep Foundations Under Lateral Load1 This standard is issued under the fixed designation D3966; the number immediately following the designation indicates the year of
Related documents
PRECAST CONCRETE MANHOLES
precast.orgapplicable ASTM Standards. Minimum compressive strength shall be 4,000 psi. • Maximum water-cementitious ratio of 0.53 specified. • A typical precast wet-cast mix has a w/c ratio of 0.38 – 0.45. • A typical precast dry-cast mix has a w/c ratio of 0.24 – 0.30. • Cement – ASTM C150, Aggregates – ASTM …
Specification for Structural Joints Using ASTM A325 or ...
www.boltcouncil.orgAn ASTM A325 or A490 bolt, an ASTM F1852 twist-off-type tension-control bolt or an alternative-design fastener that meets the requirements in Section 2.8. Inspector. The party responsible to ensure that the contractor has satisfied the provisions of this Specification in the work. Joint. A bolted assembly with or without collateral materials ...
COMPANION TO THE AISC STEEL CONSTRUCTION MANUAL
www.aisc.org60 ksi (ASTM A53) and 4-ksi normal weight concrete. Table 4-H. Available Strength in Axial Compression—Composite Filled Pipe Table 4-H is the same as Table 4-E, except it provides the available strength for filled pipe with Fy = 35 ksi and Fu = 60 ksi (ASTM A53) and 5-ksi normal weight concrete.
Specification for Structural Joints Using ASTM A325 or ...
www.boltcouncil.orgAn ASTM A325 or A490 bolt, an ASTM F1852 twist-off-type tension-control bolt or an alternative-design fastener that meets the requirements in Section 2.8. Inspector. The party responsible to ensure that the contractor has satisfied the provisions of this Specification in the work. Joint. A bolted assembly with or without collateral materials ...
Eucolastic Sealants: ASTM C 920 - Euclid Chemical
www.euclidchemical.comEucolastic Sealants: ASTM C 920 . Standard Specification for Elastomeric Joint Sealants . ASTM C 920 is the Standard Specification for Elastomeric Joint Sealants that are cured single or multi-component, cold applied elastomeric sealants. The requirements involved in the testing and their meanings are described below. ASTM C 920 Referenced Test ...
DEPARTMENT OF DEFENSE HANDBOOK
www.library.ucdavis.edunot measurement sensitive mil-hdbk-17-1f volume 1 of 5 17 june 2002 superseding mil-hdbk-17-1e 23 january 1997 department of defense handbook