Technical Data Sheet Application Guide
Application Guide Hardtop XP Jotun Thinner No. 26 is supplied and used in USA due to legislation. Nozzle tip (inch/1000) : Pressure at nozzle (minimum) : Airless Spray Equipment 150 bar/2100 psi Air Spray Equipment Pump ratio (minimum) : Nozzle output (litres/minute) : 42:1 0.9-1.9 Filters (mesh) :
Download Technical Data Sheet Application Guide
Information
Domain:
Source:
Link to this page:
Documents from same domain
Technical Data Sheet - Jotun
www.jotun.comTechnical Data Sheet Hardtop Flexi The provided data is typical for factory produced products, subject to slight variation depending on colour. Gloss description: According to …
Technical Data Sheet Application Guide
www.jotun.comEpoxy HR Product description This is a two component polyamine cured phenolic/novolac epoxy coating. It is heat resistant up to 205 °C (401 °F) and can be applied on hot substrates up to 150 °C (302 °F).
Technical Data Sheet
www.jotun.comTechnical Data Sheet Epoxy HR Surface preparation summary table Substrate Minimum Recommended Carbon steel St 2 (ISO 8501-1) Sa 2½ (ISO 8501-1) Stainless steel The surface shall be hand or machine
Technical Data Sheet - Jotun
www.jotun.comOptimum performance, including adhesion, corrosion protection, heat resistance and chemical resistance is achieved with recommended surface preparation. Date of issue:22 March 2021 Page: 3/7 This Technical Data Sheet supersedes those previously issued.
Technical Data Sheet - Jotun
www.jotun.comPackaging (typical) The volume stated is for factory made colours. Note that local variants in pack size and filled volumes can vary due to local regulations. Size of containers (litres) Aluminium Paint H.R. 5 5 Storage Volume (litres) Depending on the actual exposure of the coating system, various primers and topcoats can be used in
Technical Data Sheet Jotamastic 87 Aluminium
www.jotun.comPackaging (typical) The volume stated is for factory made colours. Note that local variants in pack size and filled volumes can vary due to local regulations. Size of containers Jotamastic 87 Wintergrade Comp B 4 5 (litres) Jotamastic 87 Standard Comp B 2.7 Jotamastic 87 Aluminium Comp A 14.7 20 3 Volume (litres) Date of issue:27 June 2017 Page ...
Technical Data Sheet
www.jotun.comLEED®v4 (2013) MR credit: Building product disclosure and optimization - Material Ingredients, Option 2: Material Ingredient Optimization, International Alternative Compliance Path - REACH optimization: Fully inventoried chemical ingredients to 100 …
Technical Data Sheet
www.jotun.comThis is a two component amine cured epoxy coating. It is a fast drying, zinc phosphate pigmented, high solids, high build product. Specially designed for new construction where short dry to handle and over coating times are required. Can be used as primer, mid coat, finish coat or as single coat system in atmospheric environments.
SAFETY DATA SHEET - Jotun
www.jotun.com1.3 Details of the supplier of the safety data sheet Product type :Liquid. Product description :Paint. 1.2 Relevant identified uses of the substance or mixture and uses advised against SECTION 1: Identification of the substance/mixture and of the company/ undertaking Product code :3140 1.4 Emergency telephone number SAFETY DATA SHEET
SAFETY DATA SHEET - Jotun
www.jotun.comSee Annex to the Safety data sheet for additional information in the Exposure Scenario(s). Consumer applications, Industrial applications, Professional applications, Used by spraying. See Section 11 for more detailed information on health effects and symptoms.
Related documents
Silestone CARE MAINTENANCE
content.cosentino.comFor difficult stains, spray Formula 409, Windex, or any other common house-hold cleaner on the affected area of the Silestone product for 2 minutes then scrub with a non-scratch scouring pad. Rinse thoroughly with water. Loss of sheen. The loss …
BLOW-IN OR SPRAY-APPLIED Insulation TIC CARD A
images.thdstatic.comMade in USA e content must be ver the insulation until the ed and documented after a minimum period of 24 hrs from the time of k y dense other than 2x4 ations. eenfiber harts. Spray-Applied Sidwall Applications (2.75 pcf minimum installed density) Framing Es t ruc a M aximum Cov er gp B (Adjusted for Framing )
DC315 Data and Application Guide - painttoprotect.com
painttoprotect.comtilation Guide, or this Guide on Moisture Control In Spray Foam Homes contact IFTI at 949.975.8588 or email us at ptp@painttoprotect.com. Ventilation: Fans may be required to circulate the air during application, especially in high or low humidity. Air flow must be across the area DC315 was applied, but not directly on it. If
WindJet Air Products, Catalog 20F - Spray
www.spray.com6 spray.com 1.800.95.SPRAY Intl. Tel: 1.630.665.5000 BLOWER AIR WINDJET ® AIR KNIFE PACKAGES QUICK REFERENCE GUIDE Model Motor Enclosure Hp/kW Voltage Amps Starting Amps Insulation Class Blower Sound Levels Performance Data, Dimensions & dBa at Weights Pressure 50760-F5.5 TEFC 5.5/4.0 208-230/ 460-3 14.5/7.55 84 @ 460V F 60 Hz: 79 50 Hz: …
FLAT SPRAY NOZZLES
www.spray.comQUICK REFERENCE GUIDE Model Connection/ Type Connection Size in. Flow Rate Range gpm (lpm) Max. Operating Pressure psi (bar) Spray Angle Materials W WIDE ANGLE SPRAY Quick-Change QuickJet® Nozzles QTKA spray tip Use with QJA or QJJA bodies NA.01 to 14.7 gpm (.037 to 55 lpm) 60 psi (4 bar) 73° to 153° at 10 psi (.7 bar) Brass, 303 stainless steel
BD Vacutainer Venous Blood Collection Tube Guide
www.testmenu.comBD Vacutainer® Venous Blood Collection Tube Guide BD Diagnostics * Preanalytical Systems 1 Becton Drive Franklin Lakes, NJ 07417 USA Invert gently,do not shake ** The performance characteristics of these tubes have not been established for infectious disease testing in general; therefore, users must