The tire model - Stanford University
the longitudinal and lateral forces necessary to change the speed and direction of the vehicle. These forces are produced by the deformation of the tire where it contacts the road during acceleration, braking, and cornering. Figure 1: Tire operating at a slip angle.
Download The tire model - Stanford University
Information
Domain:
Source:
Link to this page:
Documents from same domain
Modeling for Control of HCCI Engines - Stanford University
www-cdr.stanford.eduout of the cylinder through the exhaust valve, m˙2, po is the cylinder pressure, p, and pT is the exhaust manifold pres- sure, assumed to be atmospheric. For the reinducted ex-haust from the previous cycle through the exhaust valve, m˙3, po is the exhaust manifold pressure, and pT is the cylinder pressure,p.
Related documents
Chapter 2 Aircraft Structure - University of Florida
mae.ufl.eduIllustrates the pitch, roll, and yaw motion of the aircraft along the lateral, longitudinal, and vertical axes, respectively. Figure 2-1. The four forces. Lift and Basic Aerodynamics In order to understand the operation of the major components and subcomponents of an aircraft, it is important to understand basic aerodynamic concepts.
7. Basics of Turbulent Flow - Massachusetts Institute of ...
www.mit.eduThe ratio of inertial to viscous forces is the Reynolds number. Given the characteristic velocity scale, U, and length scale, L, for a system, the Reynolds number is Re = UL/ν, where ν is the kinematic viscosity of the fluid. For most surface ... Similar definitions apply to the lateral and vertical velocities, v(t) and w(t). A larger urms